New Engine Update

[Rio94gt]

As many of you know my 302 is long gone. I have been working with Jim Woods at Ford Strokers and Jay Allen at Camshaft Innovations to put together my new engine. Both were extremely helpfull. Im finalizing the order this week and should be expecting delivery in 6-8 weeks. Heres the specs.

Shortblock courtesy of Ford Strokers
1971 351W stroked to 408 cubic inches @ roughly 9:1 compression
4340 Forged Steel Crankshaft
4340 Forged Steel H-Beam Connecting Rods with 8740 ARP 7/16 Capscrew Bolts
351C 2.75 main bearing
Probe Industries 2618 Forged Pistons
Clevite77 Main Bearings
Clevite77 Rod Bearings
Clevite77 Camshaft Bearings
Deep Seat Freeze Plugs
Screw In Oil Galley Plugs
Fel Pro 1 Piece Rear Main Seal
ARP Main Studs
Stroker Clearanced
Chamferred Oil Return Holes
Camshaft Retainer Plate
0 Balance

Top End courtesy of Camshaft Inovations
Trick Flow TW "Fast as Cast" 190cc heads w/
- Competition Bowl Blend
- Comp Cams Titanium retainers
- Ferrea 1000 valves
Custon CI Solid Roller cam
Comp Cams "Ultra Gold" roller rockers

I cant wait to see this thing come together. Should make a little more horsepower than my 302 :rotflol:.

[George]

all mussel or powar addar motor?

[Rio94gt]

Vortech V-2 S-trim w/ upgraded Si impellar. Hoping to push 10-12 psi.

[Martin0660]

Sounds like a sweet set-up Billy.

[wick]

Yeah billy, it should make a "little" more power than the 302. HAHAHHAHAHhHAHAHHAAH

[TJH64]

That is going to be a sweet combo for sure:thumbsup:

What is your goal, et wise for this build? Should be wicked fast.

[97LaserRed]

what are you hoping to run? and what are you going to do about the tranny??

[Rio94gt]

That is going to be a sweet combo for sure:thumbsup:

What is your goal, et wise for this build? Should be wicked fast.

Me, Jay, and Woody have some ET numbers out there but its going to depend alot on suspension which will be addressed as well. It will have plenty of power.

Remember my 302 went 10.60 on a pretty basic setup.

[Rio94gt]

what are you hoping to run? and what are you going to do about the tranny??

I have a freshly rebuilt Art Carr C4 with manual reverse valve body and trans brake with an Ulitmate Converter Concepts converter waiting in the garage.:thmbsup:

[97LaserRed]

I have a freshly rebuilt Art Carr C4 with manual reverse valve body and trans brake with an Ulitmate Converter Concepts converter waiting in the garage.:thmbsup:
thats sweet!! i wish i had a transbrake when i had my auto. i just couldnt take it anymore and the swap was cheap so i went for it haha!!

[gmkillr]

This combo will fly!!!!!!!!!!!1111:thmbsup:

[SoLow]

congrats billy !