PDA

View Full Version : 9" 3.50 Traction Lok Pumpkin



PaxtonShelby
07-23-2017, 09:18 PM
For sale is a 9 inch pumpkin that I ran in my 1966 coupe. The case is from a Lincoln Versailles. I had a 28 spline Traction Lok carrier rebuilt and professionally installed with a real nice 3.50 ring and pinion. The whole thing only has about 5k miles (99% street with maybe 20 runs at the track over the last 17 years) on it since the rebuild where new bearings and clutches were used. Posi works great as I "tested" it this spring and left two nice black strips behind the car. The only reason I am selling is I decided to upgrade to a 31 spline setup with an Eaton Detroit Tru-Trac carrier.

This setup survived easily behind my manual trans small block making an estimated 425 horsepower.

My gear guy checked this out and said it is good to go - ready to be installed. Complete pumpkin, 28 spline Traction Lok, 3.50 ring and pinion, and yoke. I will have it cleaned up and ready for you. $425

I also have the Lincoln Versaillesaxles with bearings still installed ( still in great shape ), rotors, calipers, pads, flex hoses...which you could bolt into your big bearing rear. Package deal for everything...$750. Everything has 5k miles on it except the rotors, which are original and only needed turned 17 years ago...they are the good old ones that don't rust just sitting there like rotors today.

PaxtonShelby
07-26-2017, 02:01 PM
Somebody needs a nice chunk... I'd like to sell this to offset the cost of my new rear.

PaxtonShelby
07-30-2017, 05:39 PM
Still here.

gpfarrell
08-02-2017, 11:02 PM
Bump for a rock-solid guy!

PaxtonShelby
08-03-2017, 10:42 AM
Bump for a rock-solid guy!


Thanks buddy! I try. When I grow up I want to be just like you! :thmbsup:

PaxtonShelby
08-06-2017, 10:24 PM
Pumpkin is sold!!