Calhoun 6.279 and 111.5 MPH

[map351]

Just got off the phone with J.B. Calhoun and wanted to let everyone know he finally put the shakedown passes on his new Pinto.He only has an eigth mile track to play in,but the numbers are impressive.He ran a 6.279 and 111.5 MPH.The 60' was a little off at 1.5,but the car is spinning off the line and on gear changes and he has a few tune problems to work out with fuel pressure and boost.By the time the suspension is dialed in and all the tuning is complete it should be capable of 5's in the eigth and high 8's in the quarter."CONGRATULATIONS BRAD"You are definately kicking ass with a completely home built car.


Thanks everyone. Thanks Brady for taking the videos.
Especially thanks to Jon Dell Blair for troubleshooting the fuel problems and a great tune.
It is a fun ride for sure! Next time might have to add in the nitrous to spool up faster!

Brad Calhoun


Here's the Vid>> http://videos.streetfire.net/video/59fe80ca-a77a-4fe2-8ae4-986901667751.htm

[went9s]

street car?

[Darrell]

Holy christ that thing is flying!!!!!

[shawnsvtcobra]

That little sucker flys.

[yeahloh95]

wow thats awsome what turbo is he running?

[map351]

This is Brads engine..

short block mods/compression ratio/displacement: .030 Block w/Honda Oil Squirters - 9.0 JE flat top Forged Pistons - Esslinger windage tray - ARP Studs - Crower Sportsman 5.5" Rod w/cap screws - Stock Crank - Piston pins Floated - About 143 cu in
head/port work/valve size:Out of the box stock Esslinger SVO Aluminum Head
cam specs/degrees adv-ret:Esslinger Solid Roller Cam - 262 duration @ .050 - .655 lift - 300 average duration - 111.5 centerline - Running the cam straight up
intake/throttle body: Wilson 90mm
intercooler:Air/Water
nitrous system/shot size:250 shot installed but not yet being used
exhaust manifold:Custom center mount Rods SS header
turbo: SC6176E
wastegate:Turbosmart 38mm
exhaust size:4" down pipe only engine management:FAST B2B
a/f ratio, total timing, boost:11.5 - 25 - 30
fuel octane/brand/leaded or unleaded:VP C16 leaded
hp@rpm:Doing the math works out to be about 540RWHP
trq@rpm:
flex plate/flywheel:Reactor Flex Plate
convertor/clutch:Coan 7" converter
transmission:C4 w/PA Brake
rear/ratio/tire type/tire size:8.8- Strange Full Spool & Strange Axles- 4.56 - MT 28.0 X 9.0 X 15 inflated to 9psi

[fast4ord]

Badass:thmbsup:

[lib88stang]

WOW thats awesome

[map351]

Brad Calhoun ran his 2.3 Turbo Pinto last night and was running consistent 5.85 - 5.86 1/8 mile ET's with MPH from 115 to 117. With 1.25 60'

http://s6.photobucket.com/albums/y250/jbcalhoun/?action=view&current=Penwell.flv