PDA

View Full Version : Quadracer LT250R


wick
03-14-2008, 09:43 PM
Well, I am selling my quad. The one that I just completely rebuilt. Its pretty much brand spanking new. Sandblasted the frame and all other steel parts. Re-built the motor and transmission. Every bearing has been replaced and the motor has a new seal and gasket kit. Cylinder is 1.50mm over and brand new. Reeds appeared to be brand new, I did not replace them. Has a Durablue axle +1 +2. Douglas polished rear 10" rims. 2006 LTZ400 shocks. Converted to thumb throttle. Answer bars. FMF elite series exhaust. Decent tires. Looking for a fast sale at a reasonable price of $1500. Remember, this thing is basically a brand new '91 LT250R!!! The only thing that sucks is the plastic. It was yellow and not the best so I painted it black with Fusion plastic paint. Not too bad.

$1500 OBO
wick
03-14-2008, 09:49 PM
This thread will take you through most of the re-build.

http://www.steelcitystangs.com/forums/showthread.php?t=7142
somethingclever
03-15-2008, 12:44 PM
Thats a screamin deal!!! Good luck with the sale Rob.
wick
03-15-2008, 12:46 PM
Thanks John. Get that welder yet?
dpstang98gt
03-15-2008, 03:03 PM
man i really wish i didnt just buy my 02 blaster or i would be all over this...real nice looking bike man
tylerstepp
03-15-2008, 07:01 PM
pm sent
wick
03-15-2008, 09:06 PM
pm sent


Returned and called. Thanks alot Tyler!!!!
somethingclever
03-16-2008, 04:34 AM
Thanks John. Get that welder yet?



I've been putting it off so far...the nice weather is around the corner so that will be some motivation. :)

Pretty sure i'm going with a 110v Lincoln...should be good up to 3/16th.


Hi-jack over....
chevydad
03-16-2008, 10:54 AM
very good price.
wick
03-17-2008, 08:19 PM
SOLD!!!!!!!!!!!!! This was the easiest transaction I have ever had on steelcity. Thanks alot!!!
wick
03-17-2008, 08:21 PM
I've been putting it off so far...the nice weather is around the corner so that will be some motivation. :)

Pretty sure i'm going with a 110v Lincoln...should be good up to 3/16th.


Hi-jack over....

Good choice. If you get the top one, I think its a 140 amp, you should be able to go to 5/16. Its a short duty cycle on the thicker steel but its a nice welder. If you have any questions, give me a ring.
INSANELY CRAZY
03-17-2008, 08:22 PM
scs member buy it???
wick
03-17-2008, 08:29 PM
scs member buy it???

Sorta but not really. A member sent a friend my way and a deal was stricken last night.