Results 1 to 13 of 13

Thread: Patriot heads installed and running

Hybrid View

  1. #1
    Senior Member Jivepepper's Avatar
    Join Date
    Aug 2007
    Location
    Morgantown WV.
    Posts
    563

    Patriot heads installed and running

    I'm happy with the heads and overall quality of the work done at Rodeheavers. But I had and or having a few problems. None which were Tims fault. His work was totaly proffessional.

    Well, I picked up the car after having the heads installed along with a mondo bypass and a 3" exhaust. As soon as I pull out there's a big cloud of smoke and the smell of oil. I'm thinking all great the patriot curse.

    I turn around and catch Tim before he leaves work. After he investigates he noticed that every oil galley plug in the back of the drivers heads was lose and leaking. So after some wrestling around he manages to get them tight. Plus every thread had to chased on the heads as he was installing them.. The galley plugs where installed by patriot.

    I not sure if I like the sound of the exhaust. It's Mac lt's, a custom x, and dynamax bullets dumped. Kinda dump truck sounding at low rpms but screams as you get closer to 5k. I think I might also hear a slight header leak.

    It stalls at every light and stop sign. It really has a hard time finding it's idle and there's a slight miss at partial throttle. But as soon as you start applying more throttle it goes away. I can tell it really wants to haul when I start opening it up.

    I also went from Autolite 103's to AR94's

    I really hope the tune clears up the few bugs I have.
    665/540 New times coming
    Old times with 516/453 11.10 @129 Best trap 130.69 -750' DA lol
    DYNO VID ---> http://www.youtube.com/watch?v=K9uOS732mdA

  2. #2
    More RPM !!! Martin0660's Avatar
    Join Date
    Aug 2006
    Location
    Greensburg, PA
    Posts
    8,058
    Quote Originally Posted by Jivepepper View Post
    a mondo bypass .
    Quote Originally Posted by Jivepepper View Post
    It stalls at every light and stop sign. It really has a hard time finding it's idle
    I don't know a lot about the bypass you are using, but is the air meter in front of the bypass? Does it dump back into the system AFTER the air meter? Sounds like the classic "loss of metered air". In the 2,3 world we need to use a dual piston valve, then shim the upper side to get some idle quality, even then it will hunt or cycle through almost stalling, sort of stalling ,them blip, then idle after a run.

    Bob Myers

  3. #3
    Senior Member Jivepepper's Avatar
    Join Date
    Aug 2007
    Location
    Morgantown WV.
    Posts
    563
    It's after the maf and recirculated.
    665/540 New times coming
    Old times with 516/453 11.10 @129 Best trap 130.69 -750' DA lol
    DYNO VID ---> http://www.youtube.com/watch?v=K9uOS732mdA

  4. #4
    Senior Member
    Join Date
    Sep 2006
    Location
    Bridgeville
    Posts
    1,278
    I have indeed had the patriot curse. ..lets just say i wouldnt have gotten my motor build if i did get the patriot curse. oh an even talkd to the vice president of company an he didnt want to listen to my complaint that his product was defective an he even said not my problem an hung up once. srry rant over but patriot has good customer service.....NOT

  5. #5
    Senior Member Rodeheaver's's Avatar
    Join Date
    Sep 2006
    Location
    McClellandtown
    Posts
    3,482
    yes... i cant believe those plugs started leaking like that.. that car ran for at least a hour before you took it, well at least we got it fixed!! i think the tune wwill totally take out all the bugs.. i can't wait to see the new numbers.. Come on big 600hp mark!! come on!!!
    2015 A6 Mustang GT that so far has gone 9.48@147 but still the fastest prochargerd S550 in the world aside from Tim Essick's!
    www.Rodeheavershotrod.com

  6. #6
    Senior Member Ares's Avatar
    Join Date
    Oct 2006
    Location
    Pittsburgh, PA
    Posts
    2,363
    Patriot heads.....

    I do hope that is the only problem you have with those heads.
    Ed...
    2012 Ram 2500 4x4, 5.7 Hemi, leveled, 35" tires
    2004 Mustang GT - Comp Orange/5speed Best 1/4 11.94@113.64, 1/8 7.59@89.48, 1.57 60' - Best 60' 1.51, just a NA 2v

  7. #7
    Senior Member Jivepepper's Avatar
    Join Date
    Aug 2007
    Location
    Morgantown WV.
    Posts
    563
    Well I replaced the Iac and it idles alot better. But is running rich. The fumes burn my eyes in the garage, and yes I have the door open lol.

    I'm going to replace the plugs and see if it cures the little hiccup I get once in a while at low rpm and a slight bit of peddle. Other than that, so far so good. Can't wait until I tune Tuesday. Tim did a hell of a job! Thumbs up!!




    I made a little vid.
    Last edited by Jivepepper; 06-27-2008 at 10:00 PM.
    665/540 New times coming
    Old times with 516/453 11.10 @129 Best trap 130.69 -750' DA lol
    DYNO VID ---> http://www.youtube.com/watch?v=K9uOS732mdA

  8. #8
    far from a newb!!! INSANELY CRAZY's Avatar
    Join Date
    Aug 2006
    Location
    out in the woods
    Posts
    4,948
    sounds nice.. might wanna put some air in that right rear tire before you pull it out the garage..lol
    ridin fast,hittin da hills,throwin some dirt

    2003 polaris predator 500

    (wanna ride,just pm me!!!)

  9. #9
    Senior Member Jivepepper's Avatar
    Join Date
    Aug 2007
    Location
    Morgantown WV.
    Posts
    563
    Yeah lol. I ran over something on the way home.
    665/540 New times coming
    Old times with 516/453 11.10 @129 Best trap 130.69 -750' DA lol
    DYNO VID ---> http://www.youtube.com/watch?v=K9uOS732mdA

  10. #10
    Right Wing Nut Dragger Troll's Avatar
    Join Date
    Aug 2006
    Posts
    5,822
    sounds great mang, but Camera Skills > G. Pepper. I got a few beers in me, but I got dizzy and almost puked on myself watching that.

  11. #11
    Senior Member Jivepepper's Avatar
    Join Date
    Aug 2007
    Location
    Morgantown WV.
    Posts
    563
    Quote Originally Posted by Troll View Post
    sounds great mang, but Camera Skills > G. Pepper. I got a few beers in me, but I got dizzy and almost puked on myself watching that.

    Steven Speilberg would be jealous. I shot that with a digi camera lol. I can't afFORD a nice camera after my car habit.
    665/540 New times coming
    Old times with 516/453 11.10 @129 Best trap 130.69 -750' DA lol
    DYNO VID ---> http://www.youtube.com/watch?v=K9uOS732mdA

  12. #12
    Member Milewsky80's Avatar
    Join Date
    Feb 2007
    Location
    Weirton, WV
    Posts
    176
    Sounds good. I thought we were getting a tour of the house there at the end.
    -Bob
    95 Mustang GT - Bullit suspension, MGW Shifter, O/R X, MSD Blaster coil, Livewires, 17X9 A.R. Rebels, SS inserts FOR SALE!

  13. #13
    Senior Member Jivepepper's Avatar
    Join Date
    Aug 2007
    Location
    Morgantown WV.
    Posts
    563
    Quote Originally Posted by Milewsky80 View Post
    Sounds good. I thought we were getting a tour of the house there at the end.
    I don't have a house just a garage that me and the Fam live in.
    665/540 New times coming
    Old times with 516/453 11.10 @129 Best trap 130.69 -750' DA lol
    DYNO VID ---> http://www.youtube.com/watch?v=K9uOS732mdA

Similar Threads

  1. Patriot heads
    By AutomagicSN98 in forum SN95-New Edge
    Replies: 6
    Last Post: 03-06-2012, 11:20 AM
  2. patriot performance sbf heads
    By bittersweetfox in forum Ford Vehicles
    Replies: 0
    Last Post: 04-03-2011, 12:22 AM
  3. Patriot St 2 Heads W/278 Cams
    By Black02GT in forum Ford Vehicles
    Replies: 1
    Last Post: 11-01-2010, 06:12 PM
  4. patriot heads
    By bittersweetfox in forum Ford Vehicles
    Replies: 0
    Last Post: 09-09-2010, 09:49 PM
  5. Replies: 3
    Last Post: 09-18-2007, 09:19 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •