what all is need for installing transmission?

[White5.0]

im going to be ordering parts today most likely so that i can install a transmission next weekend. i want to make sure that i'm ordering everything i need and not forgetting anything.

as of now i dont have anything that goes with the driveline except for the driveshaft

heres what ill be getting:

-transmission/bellhousing
-flywheel with bolts
-clutch/pressure plate
-pressure plate bolts and dowl pins
-steel bearing retainer
-rear main seal
-new pilot bearing
-throw out bearing
-clutch fork
-transmission mount and crossmember


So, is there anything in that list that i am forgetting that goes with the driveline? also the one thing i dont know much about is the throwout bearing. can someone explain to me where this goes/what this does?

[blkp42e]

are you doing a auto to manual or does it just not have a trans, or are you upgrading???

not much info in that post

[White5.0]

are you doing a auto to manual or does it just not have a trans, or are you upgrading???

not much info in that post

i thought there was a lot of info in the first post? hahah

but i probably should have mentioned....car was previously a 5 speed and i bought it as a roller. so it already has cable and pedal assembly

[silvernotch]

block spacer plate,fork cover,clutch cable retainer clip,bolts for trans to bellhousing,bolts for bellhousing to block, and a case of coors lite!! exhaust hanger bracket for a 5spd. (auto trans is different)

[White5.0]

block spacer plate,fork cover,clutch cable retainer clip,bolts for trans to bellhousing,bolts for bellhousing to block, and a case of coors lite!!

thanks for that those are some things i wouldnt want to forget....

as for the coors, im 19 so if you'd buy it for me thatd be nice haha

[silvernotch]

oops,forget the beer, you're too young to have two bad habits! cars and beer

[cam303]

See PM about bearing retainer.

[silvernotch]

another question. Is the harness for the trans still there?

[White5.0]

oops,forget the beer, you're too young to have two bad habits! cars and beer

hahaha

See PM about bearing retainer.

got it and i pm'd ya back!

another question. Is the harness for the trans still there?

that i am unsure of i dont think i do but ill have to check when im home next weekend

[madmaxin22]

another question. Is the harness for the trans still there?

dont think i took that out before selling him the car, definately know i didnt sell one

[White5.0]

dont think i took that out before selling him the car, definately know i didnt sell one

yeah im not too sure if its there or not ill have to check...if you dont remember selling it by itself, maybe you sold it with the tranny that was in the car?

[ArmyWarrant]

That harness requires removing the seat and carpet to remove it without damaging it. Unless madmaxin did this I would say that it is still there. To the left of the shifter hole in the tunnel there should be a harness going through the floorpan into the inside of the car. Thats the trans harness.

[blkp42e]

the gear for the speedo cable

[White5.0]

That harness requires removing the seat and carpet to remove it without damaging it. Unless madmaxin did this I would say that it is still there. To the left of the shifter hole in the tunnel there should be a harness going through the floorpan into the inside of the car. Thats the trans harness.

the gear for the speedo cable

i was gonna say...i thought the whole tranny harness sat outside of the car