Advice on tire size

[Jper]

Thats under the clear coat. It will get a lot worst than it is now! Wont matter rolling down the road :)

What do you suggest?

[ddmi-twin90gt]

What do you suggest?

Man I don't know, might have to strip it, polish it and reclear them.

[Jper]

bolt them bitches up!!

nice

Man I don't know, might have to strip it, polish it and reclear them.

Thats what I was thinkin,..Theres a guy in town who does chrome and restoration work hes friends with my pap, so Imma take him down with me and talk him into hookin me up I want these babys to look sick for carslile!

[ddmi-twin90gt]

Thats what I was thinkin,..Theres a guy in town who does chrome and restoration work hes friends with my pap, so Imma take him down with me and talk him into hookin me up I want these babys to look sick for carslile!

There you go!

[Jper]

I did some research on spacers also, and came up with this..Some people say not to do spacers on 10inch rims..Some say go for it, and that theres two different kinds of spacers..In my case what do you suggest?

[97LaserRed]

if you do spacers your gonna have to roll your fenders

[casper gt]

those will fit fine no spacer, no fender rolling, no nothing. especially with bfg d/r's ( dont let anyone fool you their the smallest 315's out there I've seen & I've hard a bunch of different brands over the years) I've had 315's on 10.5's on my car for years no spacers/etc.

[Rowleyxlt619]

i have 10.5 inch wheels with 315s and i dont have any spacers and i still have the quad shocks on... no big deal...

[Jper]

those will fit fine no spacer, no fender rolling, no nothing. especially with bfg d/r's ( dont let anyone fool you their the smallest 315's out there I've seen & I've hard a bunch of different brands over the years) I've had 315's on 10.5's on my car for years no spacers/etc.

i have 10.5 inch wheels with 315s and i dont have any spacers and i still have the quad shocks on... no big deal...

Sounds good! Thanks

[FineLineMtrSprt]

Yeah bolt them on you wont have a problem. As far as the wheels finish. You would have to strip off the clear coat and then said the imperfections doin...personally if it were me i would have them powdercoated. They can blast them down to bare finish,powdercoat the center the same clor or damn close to it and leave a polished powder finish on the lip.