Thats an unbelieveable ride you got there! :D
made some noise....and some boost...and 377/442 rwhp/rwtq
My video from our Open House this past weekend...... Enjoy! :)
http://www.youtube.com/98saleen#p/u/2/ATnw1mAH2qA
Here's my recent dyno where I ran the car on pump gas only.
93 octane
18 pounds of boost
900 rwhp SAE
925 rwhp STD
I also found my Blitz boost controller is reading peak boost which is spiking on the initial hit and is about 4 pounds off from actual.
So when my gauge reads 26 pounds, I'm really only seeing about 22 pounds!!!
So my "high boost and race gas" tuneup will make significantly more than my previous 1150 rwhp once I upgrade my wastegate springs and can get an actual test on a true 28 pounds!!! I can't wait! Should be doing this around next month.
Here's the dyno sheet for the 93 octane and 18# pull.
![]()
Ur cars reaallll siickkkk!! And those open house videos r off the hooookk too! I can't believe all the burnouts n that ur allowed to do that, the roads actually black from'em! Does the police bother yunz much?
Bu-2000-bash
ALLSQUAD
Steel City Muscle Cars
CarCruises
Flashlight Drags
NMRA
UMTR
Modded Mustangs
NHSCC
Very nice pump gas numbers!
-J
'91 LX Bimini Blue
427"/88mm on 16psi
'99 Contour SVT
Clean DD
Drool.
Dan -- 2003 Cobra DSG Coupe #6009
If it looks good, you'll see it. If it sounds good, you'll hear it. If it's marketed right, you'll buy it. But if it's real, you'll feel it. IG: @donuttrump
It's been about a year since this thead had any action...... :)
Here's a recent report -
Quick Project Update -
Special thanks to Caleb for getting the Saleen on the dyno this past Friday!
We made a few pulls to check out the combo after I recently installed my new wastegate springs.
Right off the street at 22 pounds of boost it made - 1063 rwhp.
2nd pull at 25 pounds of boost it made - 1141 rwhp.
3rd pull at 28 pounds of boost it made - 1200 rwhp (pegged dyno software, but Caleb figures it would've been about 1220ish rwhp)
4th pull at 30 pounds of boost it made 1177 rwhp (lots of backpressure with 3 inch exhaust and pancaked tubes to clear front tires)
What we've determined -
1. Caleb never touched the tune. Just increased the boost pressure and the car responded each time with 11.0 to 1 air fuel ratio. So my only hold back from turning boost from 19 pounds (street) to 28 pounds is simply a matter of putting in straight 116 octane versus 93 octane.
2. Car is at the limit of its combo with the full 3 inch exhaust and muffler system. In order to make more power, I need bigger downpipes and exhaust or just take exhaust off all together.
Neither of these are choices I care to make.
However the plan is over the winter to redo my exhaust pipes around the front tires and get rid of the pancakes ( :) ) more for visual than for power (but if it helps then that is a added benefit).
This car has far exceeded my expectations.
It drives great on 93 octane and knocks out almost 1,000rwhp with cold A/C.
It makes 1200rwhp on C16 fuel with a restrictive exhaust.
It's capable of being driven anywhere.
Thanks to Caleb and Melvin for all the hard work and extra attention to detail on this project and build.
I am very happy with the end result.
VIDEO - - - - > [ame="http://www.youtube.com/watch?v=n7SkB2E-k9w"]http://www.youtube.com/watch?v=n7SkB2E-k9w[/ame]
Definitely one of the baddest street stangs out there![]()
2015 Charger Hellcat
2.4" upper pulley, ID1300 injectors, BAP, E85 tune, Cat Delete Pipes, One Piece Drive Shaft, Diff Brace, 305/35/20 555R's for the street and 305/45/18 MT ET Street R's for the track. 9.97@142 Best ET
85 GT
Heads and Cam plus other bolt ons
73 F250
Lifted, 35's, 460 4spd
Real name = Ray
That's incredable!!! I really like that pic in the garage!
Would oval tubing be a possibility?
http://www.drgas.com/oval_tubing.htm
![]()
Mark Lowry
Wolfpack Speed, Inc.4290 Campbells Run RdPittsburgh, PA 15205(412) 279-4902
Well it's been a little bit since I updated this thread.
Took the car to a local 1/4 mile race event.
Ran on my M/T 18" drag radials, 93 octane, and 19 pounds of boost.
Here's how my passes went down -
Pass 1 -
2.83 sixty foot
12.02 @ 148mph
Pass 2 -
2.14 sixty foot
11.30 @ 145mph
Pass 3 -
Broke on starting line
Twisted viper output shaft in half.
Was bogging car off line....then it would hit and spin in 1st.
2nd pass it spun and hit rev limiter in 1st and 2nd...track was not in good condition.
VIDEO --> [ame="http://www.youtube.com/watch?v=MWO2qDgt8I4"]YouTube - TTSaleen at Draggin Rights 11-2010 - Go Pro videos[/ame]
Pics of carnage -
![]()
guess it's safe to call you the highway star. Still a badass car and build no matter what et's.
2014 GT Premium - Sterling Gray Metallic - MT82 - Track Pack - Glass Roof - Recaro seats - Spoiler delete
12.76 @ 114.04 bone stock. Koni yellow coil-overs, BMR watts, LCA and LCA relo brackets, Borla S-type axle back.
1966 Coupe - 331 stroker - Bullet custom roller cam - cam and motor installed and dyno tuned by Rodeheavers Hot Rod - Astro A5 - McLeod RXT - 486 to the wheels - more fun than my little tires can handle
1966 Oldsmobile Toronado - currently NOT on jackstands
Fixing up my viper-spec T56 again (2nd time in 2 years).
Gonna keep it off the race track and it will live.
Ryan
what was wrong with it and why did it break??
2003 Sonic Blue SVT Cobra - 711 RWHP @ 671 TQ @17psi. Kenne Bell 2.8, FRPP Modular Boss 5.0 block, Big Bore 324ci, with full stroker kit, JDM Stage 3 Heads, Custom Grind Cams and alot more. 4,900 original miles..... Currently at Street Lethal Performance for a makeover!
1997 Mustang GT - 5 speed, 34k original miles
1968 Fairlane GT - 302ci Hurst 4 Speed
1999 Crown Vic - P71 Clone, JLT CAI, Dual 40 Series, Daily Driver
Bookmarks