Pic of lower intake ported

[lib88stang]

Here is a pic of my Dads lower intake he ported and knife edged. He also cut the upper and gutted it, just needs to be rotated and welded.

[Martin0660]

Looks good Shaun. Tell him to smooth it up a little, and it will look like mine :D

Bob Myers

[INSANELY CRAZY]

nice... smoother the better....

[lib88stang]

Looks good Shaun. Tell him to smooth it up a little, and it will look like mine :D

Bob Myers

Will do Bob, I'll post pick of upper tomarrow

[yeahloh95]

thats what mine looks like too, i just need to figure out what angle for the rotating

[Martin0660]

i just need to figure out what angle for the rotating

Remeber that its not just a straight rotate, it will also need a little bit of an angle cut too, or else it wont clear the hood. There is just about one place it can be on a SVO set-up so that it clears the alternator and the master cylinder (watch the throttle linkage on the MC side). When it clears them both, it's perfect ;) A few pics from mine when I was mocking it up......

http://rides.webshots.com/photo/2326...66453426NrHMLP
http://rides.webshots.com/photo/2219...66453426AYGlIX
http://rides.webshots.com/photo/2209...66453426DhDraM

This one might best show the gap on the 3G alternator and throttle linkage on the master cylinder side.

http://rides.webshots.com/photo/2975...66453426LQlpGV

I can take pictures of anything you might need, let me know.

Bob Myers