Well, I went to take out my "sweet" (JPer haha) gauges, and there is NO stock gauge face behind the gypo ones..So, after taking one needle off and peeling a part of it back, i left it on there, and put the needle back on..Well, it was a pain in the ass to get the needle to seat right again, but i finally figured that out..

What I dont understand is, should there be a stamping on MY(2002) gauges circuit board that says SN 95?!? I was a little baffled with this, not sure if these are gauges from an older stang or what..jus a lil confused..