Need help with cold air intake kit

**Dock0346** · 07-06-2009, 05:18 PM

So im gonna buy an intake kit i was thinking about a JLT i was just curious on what you guys think on which company gets the most power out of their kits? any input will help?

**Rodeheaver's** · 07-06-2009, 05:26 PM

i really like the jlt units...

**2001GTTT** · 07-06-2009, 06:13 PM

yes. get the JLT. I have the JLT ram air on my GT and I love it

**scott5** · 07-06-2009, 08:43 PM

JLTs are probably the biggest dia one you can buy and dont forget to get the inner fenderwell one. There is no point in getting a "cold" air intake if its in the engine bay sucking up warm air

**Dock0346** · 07-07-2009, 11:01 AM

ok thanks guys, another one was the upr products kit which come with under drive pulleys but it doest have a maf with it?

**RUTHLESS** · 07-07-2009, 12:18 PM

I am running the new JLT carbon fiber RAI kit on my 03 Cobra and it is sweet. The inside matches up to the throttle body exactly and shape/sweep of the bend is about as good as you can get to proved the best flow.

I did research on what kit would fit my needs the best and here is what I found. The sharp bends in the cold air kits create air turbulance and this causes the MAF sensor readings to be off a little depending on the position of the sensor. The down fall of the Ram air setup is that it pulls in hot air from the engine bay but has a much cleaner MAF signal when paired with a heat shield.