I have a 2002 Mustang GT with a stock inner tie rod. As i replaced one that recently broke i noticed when i was done that the wheel had toe pointing the tire outward about a half an inch or so. I used the DANA tie rod. Any suggestions? I counted the turns when putting the outer tie rod back on too. There should have been no issue.
So far.....
Bassani cat back exhaust, UPR off road x midpipe, cobra front brakes, subframe connector, bbk polyurethane bushings, Aluminum A-arms, k member, bbk adjustable suspension, coil overs, steeda upper and lower control arms, steeda short throw shifter, 3.73 gears, Raptor 660 clutch, smaller underdrive pulley, BBK throttle bodie, k&N cold air intake, KYB shocks and struts, and Eibach springs.
you need an alignment. your crazy if you just put a tierod on and go. how did it break??
Measure it up, get it to about 1/8 toe in and take it to get aligned.
Rob
1 Monte SS. White.
Banned dates
11/27/08
4/25/11
3/28/12
12/1/12
There are more but that's all that was logged!!!
i cant get it that close. the toe wont pull in far enough.....
So far.....
Bassani cat back exhaust, UPR off road x midpipe, cobra front brakes, subframe connector, bbk polyurethane bushings, Aluminum A-arms, k member, bbk adjustable suspension, coil overs, steeda upper and lower control arms, steeda short throw shifter, 3.73 gears, Raptor 660 clutch, smaller underdrive pulley, BBK throttle bodie, k&N cold air intake, KYB shocks and struts, and Eibach springs.
ya it was broke, long story, none the less i havent drove it. we replaced it resterday. i was going to get it aligned when we can get it closer
So far.....
Bassani cat back exhaust, UPR off road x midpipe, cobra front brakes, subframe connector, bbk polyurethane bushings, Aluminum A-arms, k member, bbk adjustable suspension, coil overs, steeda upper and lower control arms, steeda short throw shifter, 3.73 gears, Raptor 660 clutch, smaller underdrive pulley, BBK throttle bodie, k&N cold air intake, KYB shocks and struts, and Eibach springs.
why dont you go get it aligned right now and it will be fine??Originally Posted by Martini86
wasnt sure it could be pulled in that far but that was my next step
So far.....
Bassani cat back exhaust, UPR off road x midpipe, cobra front brakes, subframe connector, bbk polyurethane bushings, Aluminum A-arms, k member, bbk adjustable suspension, coil overs, steeda upper and lower control arms, steeda short throw shifter, 3.73 gears, Raptor 660 clutch, smaller underdrive pulley, BBK throttle bodie, k&N cold air intake, KYB shocks and struts, and Eibach springs.
Posting Permissions
Reply With Quote
Bookmarks