I have a 2002 Mustang GT with a stock inner tie rod. As i replaced one that recently broke i noticed when i was done that the wheel had toe pointing the tire outward about a half an inch or so. I used the DANA tie rod. Any suggestions? I counted the turns when putting the outer tie rod back on too. There should have been no issue.
So far.....
Bassani cat back exhaust, UPR off road x midpipe, cobra front brakes, subframe connector, bbk polyurethane bushings, Aluminum A-arms, k member, bbk adjustable suspension, coil overs, steeda upper and lower control arms, steeda short throw shifter, 3.73 gears, Raptor 660 clutch, smaller underdrive pulley, BBK throttle bodie, k&N cold air intake, KYB shocks and struts, and Eibach springs.
Posting Permissions
Reply With Quote
Bookmarks