Project wire tuck

[yeahloh95]

looks great rob with paint it will look even better

[wick]

Thanks Troy. It was just a quick dusting of primer. Gotta do some more then wet sand it and get it nice. Then spray it. Perhaps this week or weekend. Lots going on right now.

[wick]

Got some more done today...

[vitaleffects626]

looks awesome

[wick]

looks awesome

Thanks man!! Yours does too.

[Pure Stock]

Hey wick, you mean to tell me that k-member bolted up or did you spark up the acetylene outfit?

[wick]

This one fit like a glove...

[Silverhatch]

Looks great brother! Clean.

[wick]

Thanks Brian. Cell pics do no justice to this.

[biminiLX]

Thanks Brian. Cell pics do no justice to this.

Awesome results, look forward to seeing it one of these days.
-J

[wick]

Thanks J.

Notice how the mounts to the frame do not stick out like the QA1 or others also. It actually fits the way a K member should fit. Very happy with these results so far. No nightmares or headaches yet. And I use that term very loosley. HAHA

[wick]

Got a good bit dont last night. Waiting for my Camber plates. No big deal. Almost ready for the engine to go back in though. Drilled a 2" hole right in the center for the 10 pin, o2 and Distributer harness. Once the motor is back in it will be hidden. Lengthened the wiper harness and ran it through the cowl.

[wick]

I have not gotten the nerve yet to cut a hole for the power pipe. I might do something else with that. Not sure yet though. Wires are run for the maf as well. Just gotta figure exactly where its going to go before I drill into the engine bay. I might get bored tonught and throw the engine in. Not sure yet. May just do the brake system instead though.

[vitaleffects626]

wick where did you get that gromit for the fi harness

[gmkillr]

Looking good bud!

[wick]

wick where did you get that gromit for the fi harness

I actually made it. I got a plug from a T-bird, did the hole then used a razor to open the hole in the plug for the harness. I kinda figured you were waiting to see what I did for mine. HAHA I was waiting to see what you were going to do. There was a good bit of trimming I had to do with the insulation. I can give yolu details if you want. The insulation is so thick, after trimming it, there is no load on any wires and they all move freely if need be. I assume your dash is out right? Stop over and check it out if you want

Looking good bud!

Thanks Robert!!

[wick]

I will say this though, it was a bitch getting the ten pin through a 1" hole. Not to mention everytrhing. The rubber did stretch some but it was just tough. Worth it though.

[wick]

Update pic...

Interior in almost all back in too. Just the console is left.

[cwh19]

Did you flip the intake to run the intercooler from the driver's side?

[silvernotch]

Is that your throw out bearing on the left strut mount??