Results 1 to 20 of 20

Thread: Car keeps stalling???help lol

  1. #1
    Clean mineralrob's Avatar
    Join Date
    Nov 2006
    Location
    Pittsburgh
    Posts
    1,994

    Car keeps stalling???help lol

    As i was driving today my car shut off and continued to do so. The rpms will drop really low then it just shuts right off. No check engine light or anything. Sometimes it will start right up and drive fine then you come to a light and nothing,just shuts off. I've to keep it revved or else it will stall. I read something on another forum with some guys having similar problems and the intake air controller was brought up alot and was told that i could just try and clean it instead of replacing it. Any ideas??? On my old avenger i had a simliar problem and it was the crank position sensor?? My rides an 02 5spd gt with 11,000 miles. Help!!
    Last edited by mineralrob; 02-24-2007 at 07:42 PM.

  2. #2
    Formerly 2011 GB/CS & CST 03 03 OW SVT's Avatar
    Join Date
    Sep 2006
    Location
    Fuwkawee
    Posts
    5,151
    I had a car that did that once. It turned out it was the alternator that was bad. The car was running off the battery and draining it, causing the car to stall.
    17 Ram 1500 Big Horn Hemi
    16 Comp O GT Performance Pack
    03 Oxford white Cobra (Gone but not forgotten)

  3. #3
    Bigger IS better! Smallville's Avatar
    Join Date
    Feb 2007
    Location
    Pittsburgh, Pa
    Posts
    459
    Definitely sounds like an IAC to me. Try tapping on it with a screwdriver and see if changes your idle, or if it will idle at all. You can try cleaning it but that usually only helps when the idle is too high (carbon buildup keeps the pintle from closing, not so much keeping it from opening). Try swapping it with another (try borrowing one first, they're not a $10 part ) and see if the problem goes away. But with no "check engine" light, hints to me that the computer doesnt "see" the problem, and that the other sensors are working as well. Pretty sure I have a one if you want.

  4. #4
    Clean mineralrob's Avatar
    Join Date
    Nov 2006
    Location
    Pittsburgh
    Posts
    1,994
    Yea i just tried cleaning it and that didnt work so i'm assuming thats its prob bad. You've to keep it revved or the idle drops down and it stalls out.

  5. #5
    Senior Member 383taman's Avatar
    Join Date
    Jan 2007
    Location
    shaler,pa
    Posts
    1,010
    Clean the mass air flow meter problem solved ill bet ya

  6. #6
    Senior Member Rodeheaver's's Avatar
    Join Date
    Sep 2006
    Location
    McClellandtown
    Posts
    3,482
    if you want max performance all the time you need to keep that mass air meter clean as a whistle, i clean mine in my expedition alot just to keep the gas gauge happy and high... So it is deff a good idea to try
    2015 A6 Mustang GT that so far has gone 9.48@147 but still the fastest prochargerd S550 in the world aside from Tim Essick's!
    www.Rodeheavershotrod.com

  7. #7
    Going fast with class Slow01GT's Avatar
    Join Date
    Aug 2006
    Location
    Mars, PA
    Posts
    1,696
    Same thing happened to me a while back. A new idle air control valve solved the problem but you might be able to get away with just cleaning iac valve with some carb cleaner.
    Dennis
    2006 GTO
    Gone but not forgotten

    2015 SHO
    Mostly stock

    2014 Cruze
    Living the MPG life

  8. #8
    Senior Member
    Join Date
    Aug 2006
    Location
    Farmington WV
    Posts
    4,672
    happened in my 98 GT. new iac and it was fine. its about a $60 part if memory serves me correct

  9. #9
    Clean mineralrob's Avatar
    Join Date
    Nov 2006
    Location
    Pittsburgh
    Posts
    1,994
    Yea i tried cleaning the IAC last night so i'm assuming its bad.

  10. #10
    Clean mineralrob's Avatar
    Join Date
    Nov 2006
    Location
    Pittsburgh
    Posts
    1,994
    Also what should i clean the mass air meter with??electric parts cleaner,carb cleaner etc???
    Last edited by mineralrob; 02-25-2007 at 08:31 AM.

  11. #11
    Clean mineralrob's Avatar
    Join Date
    Nov 2006
    Location
    Pittsburgh
    Posts
    1,994
    Bump anyone local to me maybe with more knowledge than me want to take a look at it??or here it??? cause from what i'm being told its the IAC thats bad but i kinda want make sure thats the problem before i purchase it.
    Last edited by mineralrob; 02-26-2007 at 08:25 AM.

  12. #12
    Kickin it Old School somethingclever's Avatar
    Join Date
    Aug 2006
    Location
    Bentleyville
    Posts
    4,625
    Quote Originally Posted by mineralrob View Post
    Bump anyone local to me maybe with more knowledge than me want to take a look at it??or here it??? cause from what i'm being told its the IAC thats bad but i kinda want make sure thats the problem before i purchase it.
    Remove the IAC on the TB....be careful not to mess up the gasket. clean with carb cleaner....move rod in IAC valve back and forth a few times...make sure it moves freely. Reinstall...if you still have the same problem...try cleaning the MAF as previously mentioned with ELECTRONIC PARTS CLEANER ONLY.
    -JOHN

    Carburetors and SAE wrenches.................


    Buy Made in the USA - It Matters.

  13. #13
    Clean mineralrob's Avatar
    Join Date
    Nov 2006
    Location
    Pittsburgh
    Posts
    1,994
    I'm going to go outside and try the MAF and i will report back with the results. grrrrr i dont have any torx bits, well atleast where i'm at right now i dont so off to the auto parts store.lol
    Last edited by mineralrob; 02-26-2007 at 10:14 AM.

  14. #14
    Senior Member coralcoupe1993's Avatar
    Join Date
    Sep 2006
    Location
    Robinson
    Posts
    3,842
    It could be a few things. I am in Robinson if you want to bring it over? I had that issue when my IAC went. I cleaned it and it worked fine for about a month but I had to change it.
    87 GT
    93 Notch
    60 Country Sedan
    Fairlanes/Galaxies 59-68
    67 Contiental 4 door
    06 Powerstroke

  15. #15
    Clean mineralrob's Avatar
    Join Date
    Nov 2006
    Location
    Pittsburgh
    Posts
    1,994
    Update. I actually fixed it a about a week ago but it was the IAC. Thanks for everyones help.

  16. #16
    Member
    Join Date
    Feb 2007
    Location
    Kittanning,Pa
    Posts
    224

    Stalling

    My 98 stalls also the same way your car does. I dont want to sound stupid but where is the IAC located to clean. My will run very rough for a while then finally start running right after a while
    Thanks Bryan

  17. #17
    Senior Member
    Join Date
    Aug 2006
    Location
    Farmington WV
    Posts
    4,672
    it is on the front of the upper plenum. (assuming 98 GT)
    Attached Images Attached Images
    Last edited by J-rod; 04-17-2007 at 10:44 AM.

  18. #18
    Member
    Join Date
    Feb 2007
    Location
    Kittanning,Pa
    Posts
    224

    stalling

    I found the IAC how do you get to it i took the two screws off and the plactic cover come off how do you get in their to clean it
    Thanks Bryan

  19. #19
    Senior Member
    Join Date
    Aug 2006
    Location
    Farmington WV
    Posts
    4,672
    only those two screws and the connector plug holding it on...could be stuck if original....give it a few taps with a screwdriver or something....it will come off.

  20. #20
    Member
    Join Date
    Feb 2007
    Location
    Kittanning,Pa
    Posts
    224

    iac

    Is that pin in there need to be removed and do I pull it out with pliers I think I took off the TPS I will look for the IAC
    Bryan
    Last edited by hunter31; 04-17-2007 at 03:52 PM.

Similar Threads

  1. Car stalling when A/C is on
    By street591 in forum General Tech
    Replies: 6
    Last Post: 03-30-2010, 12:22 AM
  2. car stalling at red lights
    By regan in forum SN95-New Edge
    Replies: 13
    Last Post: 06-21-2009, 12:56 AM
  3. Help! Stalling issue..
    By pRojekt02GT in forum General Tech
    Replies: 2
    Last Post: 05-31-2009, 03:35 PM
  4. 4x4 car..lol
    By INSANELY CRAZY in forum The Bar
    Replies: 10
    Last Post: 12-27-2007, 10:49 PM
  5. 96 cobra stalling
    By Mr. Rob in forum SN95-New Edge
    Replies: 7
    Last Post: 04-04-2007, 12:04 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •