93 Mustang engine and wiring

[jaa55]

Less than 5000 miles on the rebuild COMPLETE MOTOR intake to oil pan!
GT-40P ported heads
FMS F-cam
Explorer intake (latest pictures shown with cobra upper I have)
K member
Complete engine bay wiring (distribution box, headlight harness, ECU harness+ engine harness, A9L computer)
vacuum hoses
can sell with either 24 or 19lb injectors
Mustang intake tubing +MAF meter (either stock or the one calibrated for 24s)
fuel rails
distributor +MSD cap and rotor
coil
Ford racing wires + new plugs
all sensors
Flywheel + new RAM clutch
Bellhousing for t-5
even down to the rad hoses
Power Steering pump
A/C pump + lines
new water pump
brand new 3G Alternator 120 amps
Air pump delete idler
FMS stainless steel ceramic coated headers

Optional stuff:
Bassani Stainless steel X pipe
MSD 6AL

This motor is still in the car and you can hear it run! this motor is clean!

$1200 without optional stuff

[White5.0]

I can vouch for this engine. i've rode in it and drove it before. runs very strong sounds good and doesnt smoke. buyer wont be disappointed . i also know jim personally and he isnt the kind of guy to screw you over

[vitaleffects626]

Jaa I'm trying to get some money lined up u wouldn't sell me it minus dizzy intake alt wireing harness ecm would you

[jaa55]

Thanks Ryan!

I'm going to try to sell it all in one chunk at first, its not impossible that i may part it if dont get someone interested in all of it

[jaa55]

someones got to have a roller/older fox they could use this in!

[jaa55]

sale pending....

[89stang]

Did you sell it?

[jaa55]

yes, its sold. I got the cash on tuesday