I bought a auto meter temp sensor and light. I have a Cobra lower, and I cant find a place to install the sensor. Anyone ever done one of these before? Can i get a brass tee and some fitings to tie it in where the guage connects? It senses 220 degrees. Thanks
MSD ignition/King Cobra clutch/Polished Cobra upper and lower/Ported GT40p w RR/ 70mm tb/ 24 lb injectors/ pullies/ Mac cold air/ Mac long tubes/ H pipe/ 3:73 gears/ 3g alt/ welded sub frames/ Alum driveshaft/ CC plates/125 shot of juice/custom trunk/suspension goodies.
FIRST PLACE 87-93 FOX BODY BUCKEYE STANGS SHOW 2010 AT SUMMIT RACING
283 hp / 320 tq on mustang dyno (all motor)
Passenger rear of the intake. There is a port you can use. Never did one though.
Rob
1 Monte SS. White.
Banned dates
11/27/08
4/25/11
3/28/12
12/1/12
There are more but that's all that was logged!!!
i did mine on the drivers side of the block, there was a screw out plug. just put it right in there
Posting Permissions
Reply With Quote
Bookmarks