Mike, what brand of this do I want? Do you or Lou sell one? Also whats needed to install this? Is it pretty simple? Thanks!
After you left I cut a 1.56 60ft but missed 4th. I'm definitely in need of a clutch but I'm gonna try going back out on the stocker one last time. I want that mid-11 pass before I start tearing into shit.
Billet flow or steeda both work fine. Give me a shout tomorrow, I may have a steeda on the shelf.
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
How you miss 4th! Install isn't bad for me, I don't know about youOriginally Posted by ModularMike
Mike, what brand of this do I want? Do you or Lou sell one? Also whats needed to install this? Is it pretty simple? Thanks!
After you left I cut a 1.56 60ft but missed 4th. I'm definitely in need of a clutch but I'm gonna try going back out on the stocker one last time. I want that mid-11 pass before I start tearing into shit.The clutch is what is holding you back, Lou has all the parts you need either way
Wolfpack Speed, Inc.4290 Campbells Run RdPittsburgh, PA 15205(412) 279-4902
I missed 2nd, 3rd, and 4th that night! It seemed like the clutch pedal was right off the floor and I may not have had it to the floor when I shifted. Not a fan of the Pro5.0 shifter in it either. I'm gonna play with it for a little bit and see if I can get it shifting better.How you miss 4th! Install isn't bad for me, I don't know about you
Mike how much you want to install it? I'm gonna tell Lou I'll take that one he has laying around.
Just ring me at the shop when you are ready and we will figure it out then..
Wolfpack Speed, Inc.4290 Campbells Run RdPittsburgh, PA 15205(412) 279-4902
Posting Permissions
Bookmarks