Buy new trays as well. Get the ls2 trays since they have a better design than the junk ls1 trays
Buy new trays as well. Get the ls2 trays since they have a better design than the junk ls1 trays
Dennis
2006 GTO
Gone but not forgotten
2015 SHO
Mostly stock
2014 Cruze
Living the MPG life
I have those also
Got side tracked today but here is where I left off. Bottom middle head bolts on drivers side were a whore and I couldn't for the life of me get the header out of the way but I finally got it.
Picked up LS7 Lifters and LS2 trays from Brian thanks again.
Didn't do much today, lots of running around. Pulled the lifters and trays, cleaned the deck, bolt holes, and cylinders. Got the starter out and the crank pulley bolt loose, now I need to pull the crank pulley off. Tomorrow I should be taking the old cam out and putting the new one in. Also got the valve springs installed on my new heads.
Last edited by ModularMike; 03-08-2011 at 01:30 AM.
Nice spring tool
Dennis
2006 GTO
Gone but not forgotten
2015 SHO
Mostly stock
2014 Cruze
Living the MPG life
Thanks I had to blow some cavalier driver to use it,
Pfffffff Thanks Mike!
Old cam out..
New cam in!
Yesterday put the timing cover and pulley on:
Today got the heads on and torqued down..
Wow looking good, gonna be a completely different animal when you are done!
03 Cobra=slow show car...
13 F-150 Limited
Valvetrain in and torqued down and headers on:
Bookmarks