On my 89 GT it has Eibach springs part #'s 3510.301 Front and 3510.302 Rear. The left side of my car sits about 2.5 inches lower than the right side. On the rears the end of each spring pigtail is pointing to the drivers side. The front feel like they are in the pockets but not 100% sure. Any suggestions? Can these springs just be tossed in or do they need to seat in a certain position? BTW Iposted this on Stangnet too...
1989 GT
STOCK 302
FLOWMASTERS
O/R H PIPE
This is just a possible guess....
Did you remove or replace any control arm/bushings? If so you need to have the car's
weight loaded on the control arms (using your jack) before tightening the bolts. If you
just let them hang and tighten the bolts the bushings will have pre load. In your case
it could be the corners that are higher than the others.
Posting Permissions
Reply With Quote
Bookmarks