A couple part suggestions...

**TooFast98Cobra** · 10-15-2010, 01:04 PM

Hey Scott I would like to see you make a passenger delete panel for the airbag and also a delete panel for the radio,vents etc.. middle of my dash in my sn95. only places out there for that piece is Florida 5.0. I am wanting to have my entire interior have the alum look. If you could look into those two pieces I think they would be big sellers. I'd buy them asap. I'll be in touch soon also for your rear seat delete and inner fender aprons, thanks Bill

**Scott Rod Fab** · 10-16-2010, 01:40 PM

Bill, I am striping my wifes 98 apart now, so I will be making templates of the dash pieces. I will have to look at the air bag delete, to see we can come up with something for you. Keep the ideas coming.
Thanks, Scott

**TooFast98Cobra** · 10-16-2010, 01:48 PM

thanks man, you could even make holes in the center dash piece for 2 1/16 gauges, there are companys out there with this already but not in alum! Also look into making a gauge cluster alum piece with like one 5in hole and 4 2 1/16 holes. I know they would sell well. People try to fab sheet metal in those places and it ends up looking mickey mouse, maybe I'll take a ride over with J soon and talk

**Scott Rod Fab** · 10-16-2010, 01:55 PM

I just finished mocking up a panel for the gauge cluster. Her car is getting 2, 2 3/8" tach and speedo, then two small 2 1/16" next to them. I was going to put the other 2 guages in the radio delete panel. As soon as I get them cut I'll post some pics.