Im selling my trick flow roller rockers. 3/8 studs, 1.7 ratio for a small block ford. These all worked great on my car before removing. All look fine after inspecting. I did have to put a small notch on two of them to fit under the stock valve cover where the bafle was but did not affect their structure or strength. Asking $190...
Link http://www.summitracing.com/parts/TFS-51400511/
bump..
Think these would fit under stock "powered by ford" 84/85 valve covers?
Not sure they did fit under my stock ones with a little thicker gasket and I notched two that did rub which doesnt effect the structure.
Those were the 86.93 EFI valve covers?
I'm really only interested if they will fit under mine.
I'm using the Felpro blue reusable gaskets with these covers.
The valve covers I used with the same gasket as you were AFM which looked like stock height and they fit fine. If I could tell you they would fit for sure I would but I dont know.
http://www.andersonfordmotorsport.co...emart&Itemid=1
Posting Permissions
Reply With Quote
Bookmarks