Anybody have any experience with hydraulic roller lifters that will handle 7,000 rpm+? I understand cam lobe profile/ramp rate also play an essential part in contributing to valve/lifter float.
Been doing some research and found these names Morel, Eaton, Sherman. Any experience with these manufacturers?
2011 Mustang GT, MT-82, 3.73's :
BONE STOCK 12.223@115.18
I thought that eaton made the fms crane, & com cams lifters, but comp cams takes their's and adds a better spring & plunger to handle the rpm better, the comp cam lifters are suppose to be the best of the 3. They are suppose to be good to 7500 according to Jay Allen.
Corvette Z06
Growing up.............Not everyone does it!
No. I was spinning a 408 to about 6800. I ran solids. Call Anderson Motorsport. I think they have a high RPM hyd combo????????Originally Posted by Pure Stock
87 GT
93 Notch
60 Country Sedan
Fairlanes/Galaxies 59-68
67 Contiental 4 door
06 Powerstroke
I'm running eaton's in my car Joe, but I don't see anywhere near the rpms you are talking about. I know these lifters are the same used in some pure street combos, but like you said, a lot has to do with the cam profiles.
-Paul
1995 GT 'vert
Best times on old 302 combo:
12.03 at 112.5mph NA
Best time with 9:1 compression NA dart block 331 setup:
11.50 at 121mph
Dyno'd: 415rwhp/410rwtq
2004 Z16 commemorative edition Z06
100% stock: 11.9 at 118mph
Anything on the Morels??
2011 Mustang GT, MT-82, 3.73's :
BONE STOCK 12.223@115.18
Who is grinidng your cam? Did they recomend any type of lifter? I am assumeing that 7000+ you are not using an off the shelf cam.
87 GT
93 Notch
60 Country Sedan
Fairlanes/Galaxies 59-68
67 Contiental 4 door
06 Powerstroke
On the contrary, it is an off the shelf bump stickI am just wanting something with a little *cushion*;)
2011 Mustang GT, MT-82, 3.73's :
BONE STOCK 12.223@115.18
Posting Permissions
Reply With Quote
Bookmarks