#1
i was thinking GT40 heads and intakes with an F cam.
this is for budget and decent power...still blower or nitrous freindly.
#2
cobra intakes/ ???? heads, with an F cam
#3
what i need to run an X cam or similar?
my plans are to gather all my parts (performance and body) for 12-18 months...then park the car for a few months for a complete makeover. :D mainly cause i have no garage and wont have my own for about 2 years. :(
Hey Jared, is your pm box full again?
not anymore. :)
i say best way to get your power would be trickflow stage 2 cam, trackheat intake, and twisted wedge heads, and a wet shot of spray. just my .02
yea i had someone else recomend saving for the TF heads. not sure on the stage 2 cam....never looked at it.
im thinking about leaning to the cobra, edelbrock, or typhoon intake...as their new cost is a little more than id pay for used explorer intakes.
with the P heads or just regular 40s. if my old research was right they dont like over .500 lift all that much unless they are ported
Posting Permissions
Reply With Quote
Bookmarks