Results 1 to 7 of 7

Thread: TTSaleen back on the dyno!!

  1. #1
    Twin Turbo Saleen 98saleen's Avatar
    Join Date
    Mar 2008
    Location
    NC
    Posts
    179

    Talking TTSaleen back on the dyno!!

    1. New exhaust setup from downpipes to axles including new magnaflow mufflers. These things are MUCH quieter than my dynomax (or RUSTomax as they are now known).

    2. Check tune on dyno. Some very slight changes on the driveability but no changes on the wide open throttle tuning needed!

    Car lost 70rwhp at the same boost level on 93 octane. Prior numbers with the manual were 965rwhp and now it makes 895rwhp.
    Only 18 pounds of boost on the peak but averaged 16 pounds throughout the run.
    No high boost runs or race gas as currently it just isn't necessary.
    Only after I master my skills with the pump gas setting will we try to turn it up......at least we might.

    I need to adjust my boost controller now and then install a rollcage.
    Car TWISTS up BAD both on the dyno and the street! The new found power application (auto) is really putting the power to the ground now!

    As soon as it's track SAFE, look for it at a 1/4 mile near you! LOL!!

    Ryan

    [ame="http://www.youtube.com/watch?v=ggrr9GtPg4I&feature=channel_video_title"]Twin Turbo Saleen 11-2011 Dyno with auto @ Fastlane Motorsports - YouTube[/ame]

  2. #2
    Did you run the 1/4 with the stick?
    1969 Camaro restomod/project
    1967 camaro
    2011 mustang procharged
    93 reef blue notch blk/int
    92 calypso notch blk/int
    86 t-type
    1972 chevelle project
    Not only did I fail at building a fast mustang but I bought a yellow zo6 cause I couldn't get my little dick up.

  3. #3
    No Traction due to Paxton PaxtonShelby's Avatar
    Join Date
    May 2007
    Location
    Moon Township
    Posts
    11,377
    Wow - that's a serious car!!
    2014 GT Premium - Sterling Gray Metallic - MT82 - Track Pack - Glass Roof - Recaro seats - Spoiler delete
    12.76 @ 114.04 bone stock. Koni yellow coil-overs, BMR watts, LCA and LCA relo brackets, Borla S-type axle back.

    1966 Coupe - 331 stroker - Bullet custom roller cam - cam and motor installed and dyno tuned by Rodeheavers Hot Rod - Astro A5 - McLeod RXT - 486 to the wheels - more fun than my little tires can handle

    1966 Oldsmobile Toronado - currently NOT on jackstands

  4. #4
    Twin Turbo Saleen 98saleen's Avatar
    Join Date
    Mar 2008
    Location
    NC
    Posts
    179
    Quote Originally Posted by went12s View Post
    Did you run the 1/4 with the stick?
    Yep.
    Typical 60 foots of 2.2 to 2.4.
    Would either bog or spin each time.
    Only started to recover in 3rd gear and charged hard to finish line.
    Ran low 11's at 148mph on my pump gas tune.

    Now that the car won't have a bogging problem, I just need to work on the suspension, roll cage, etc and get all this power to the ground.

    My goal is 9 seconds in the 1/4 on pump gas and 18" radials.

    Ryan

  5. #5
    Senior Member Dan B.'s Avatar
    Join Date
    Sep 2009
    Location
    Armagh, PA
    Posts
    4,331
    If you were trapping at 148mph before, getting well into the 9's should not be a problem.
    Quote Originally Posted by John4cam View Post
    Ahh fuque
    1985 Ranger--2WD, basic bolt-ons and tires, 11.92 @ 111mph.

    1986 Ranger--2WD, 5.0/T5/8.8.

  6. #6
    No Traction due to Paxton PaxtonShelby's Avatar
    Join Date
    May 2007
    Location
    Moon Township
    Posts
    11,377
    If your 60' is 2.2 - 2.4, could you try launching in 2nd gear at a lower rpm? It would keep the boost from building up too early and you wouldn't blow off the tires until you're about ready for 3rd gear?? Just a thought.
    2014 GT Premium - Sterling Gray Metallic - MT82 - Track Pack - Glass Roof - Recaro seats - Spoiler delete
    12.76 @ 114.04 bone stock. Koni yellow coil-overs, BMR watts, LCA and LCA relo brackets, Borla S-type axle back.

    1966 Coupe - 331 stroker - Bullet custom roller cam - cam and motor installed and dyno tuned by Rodeheavers Hot Rod - Astro A5 - McLeod RXT - 486 to the wheels - more fun than my little tires can handle

    1966 Oldsmobile Toronado - currently NOT on jackstands

  7. #7
    Built, Cammed, CCW'd SVT NateSVT's Avatar
    Join Date
    Aug 2006
    Location
    Monroeville
    Posts
    856
    Launching in 2nd gear it would just bog even worse and take much longer to spool. 2 step and good ass tires should get much better than a 2.2 60'.
    2004 SVT Cobra - sold
    2000 Yamaha R1
    2006 Yamaha R1 - Raven


    10.89 @ 127.6 1.61 60' with a ported Eaton

Similar Threads

  1. Replies: 9
    Last Post: 11-04-2013, 06:28 PM
  2. Back from the dyno.
    By Jivepepper in forum General Tech
    Replies: 31
    Last Post: 04-07-2009, 09:10 PM
  3. Back from the dyno again lol.
    By Jivepepper in forum The Bar
    Replies: 30
    Last Post: 07-24-2008, 02:20 PM
  4. Replies: 29
    Last Post: 06-18-2008, 10:27 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •