I have a pile of misc stuff, here is the first pass at it. Everything is best offer, picked up here in Greensburg PA
Turbo XS High Performance Boost Controller (BC-HPBC). These are about $100.00 new. Very good manual boost controller, ball and spring type with adjustable bleed - $50.00
Carbon Fiber traction lock clutch discs, used. Best for when you are doing an alternate stack to add two additional clutches. 6 total - $25.00 for all or will split up in pairs
Grand National turbo inlet. Use this on a Ford T3 turbo to have a straight inlet. Side outlet is tapped for 3/8" NPT (for valve cover breather). $30.00
Aftermarket adjustable waste gate actuator for T3 turbo pattern. New, never used. I have never tried this on a 2.3 application, I've just had it around - $40.00
Dual port Wastegate actuator and mounting bracket for T4 compressor. Very adjustable set-up - $60.00
UPR Tripple hood quadrant for FOX. Quadrant is new, includes one spacer and plastic washer. Not sure if there is other misc hardware needed - $30.00
Autometer Phantom boost gauge. 30" - 0- 30 psi. Mounting studs are cut off the back for use in a pillar pod or gauge cup (cant use U clip) - $25.00
Aluminum brackets for mounting a truck cap on a truck bed - New - $20.00
Large NPR Intercooler ... Includes silicone couplers shown, one side to 2 1/2" on side to 3". Cooler is not perfect, but worked great on my junk. Area on the bottom was corroded and has aluminum patch epoxied over it (no leak). Also has typical ding from hood latch and typical fin damage. - $100.00
Electric fan for Fox Mustang. The FAN works but the thermostat controller is dead.
$40.00
T3/T4 Turbine blanket. Has a good bit of wear on one side and edge, still functional. $25.00
Boost Controller and GN Inlet sold
Traction lock clutches sold on another board
Posting Permissions
Reply With Quote
Bookmarks