The car is wrecked but still has some good red interior, good running 5.0 and a good 5 spd. I will post pictures tomorrow.
The car is wrecked but still has some good red interior, good running 5.0 and a good 5 spd. I will post pictures tomorrow.
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
Sale pending on the complete 5 speed swap.
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
good front seats?
1969 Camaro restomod/project
1967 camaro
2011 mustang procharged
93 reef blue notch blk/int
92 calypso notch blk/int
86 t-type
1972 chevelle project
Not only did I fail at building a fast mustang but I bought a yellow zo6 cause I couldn't get my little dick up.
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
Motor and trans, sale pending.
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
let me know if the deal falls through with the 5 speed. i need one.
also i need a gas tank with the short wiring harness from the pump to the main harness. thanks
sent you a PM about the master cylinder and proportioning valve... need one from an 87+... (or if anyone else has one)
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
Here are the pictures of the beauty.
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
Would the center console fit my 86? Also, I need the piece that is inside the steering column that click when you turn the turn signals on, would the one from this car work?
Black 1998 GT- PI swap, 3.73's, off road h pipe, flows & some suspension goodies
White 1986 GT T-Tops- BBK shorties, RAM clutch/flywheel, Bassani catted x pipe, MSD ignition, MAC cai, LMM lowering springs, adjustable skocks & struts, MGW short throw, DD
Black 2009 Yamaha YZF-R6- custom levers, -1 front sprocket, Jardine GP-1 exhaust, HIDs, custom undertail, custom black windscreen.
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
Shorty429, I have a MINT condition grey center console, with electronics and everything, no breaks, chips or scratches... not sure what it is worth, and I was planning on using it to replace my "ok" one in my 85GT, but for the right price, everything is forsale :)
PM me an offer if you're interested.
And Sonic03snake... thanks for the brake stuff! 1 step closer to finishing my car!
How is the trim from door to trunk hinge. The piece the boot fits into. Is anything broke, like the attachments. Thanks!
Black 1998 GT- PI swap, 3.73's, off road h pipe, flows & some suspension goodies
White 1986 GT T-Tops- BBK shorties, RAM clutch/flywheel, Bassani catted x pipe, MSD ignition, MAC cai, LMM lowering springs, adjustable skocks & struts, MGW short throw, DD
Black 2009 Yamaha YZF-R6- custom levers, -1 front sprocket, Jardine GP-1 exhaust, HIDs, custom undertail, custom black windscreen.
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
Are the qt window in working condition like the motors and are they on track ?
Bookmarks