my new stance - undecided

**J-rod** · 04-05-2007, 06:13 PM

well as you know we did the rear end almost 2 weeks ago now. we used the poly iso's and it was a BITCH to get them in there. but we finally did it and immediately i was unhappy....it sat too high. not like the C springs i usually run. so we gave it (12 days today) time to settle and its still too high. it looks to sit even higher now with the front being lowered. Timmy finished the front last night. didnt use the iso's up front due to not being able to fit them in at all. he tried for a while too.

so now im unsure what to do. should i A) keep it as is, it will settle more...if not at least i can run a bigger tire in back. or B) remove top rear iso and try to level it out some more?

here are some pics.

#1 is out front of my place.
#2 is in a more level lot
#3 is the rear up close
#4 is front up close

**INSANELY CRAZY** · 04-05-2007, 06:18 PM

try bigger tires... if you take the iso's out, it may wind up being lower again in the back

**J-rod** · 04-05-2007, 06:19 PM

i was only gonna take out the top iso and leave the bottom in

**Troll** · 04-05-2007, 06:21 PM

Personally, I think it looks good. Most foxes have the back end all worn out and squatting down like there's two dead goats in the back. That has a nice rake to it. Looks old school. It should settle some more. 12 days ain't that long. Put a couple kegs in the back and drive around for a while. Hell, bring 'em to my house. I'm only about 20 miles further than Rodeheavers.