4.6 horsepower add ons

[98gt]

anyone know the best way to get anywhere close to 350 at the wheels on the junk 4.6 block? would like to rebuild the engine, has close to 130000 on her

[John4cam]

Small shot of juice, or an entry level blower. Basic bolt ons won't do it

[stevec5ws6]

N2O cheapest easiest way.

[98gt]

Small shot of juice, or an entry level blower. Basic bolt ons won't do it

whats your thoughts on putting a blower on an engine with close to 130000 miles on it? should i look into some forged internals?

[John4cam]

whats your thoughts on putting a blower on an engine with close to 130000 miles on it? should i look into some forged internals?

If you want low boost and 350 RWHP I'd leave it alone. If the tune is right you should be fine.

[98gt]

was thinking about this...
http://www.latemodelrestoration.com/...ngine-Kit-44CC

not too sure if its worth the $$$ though

[somethingclever]

stock 130k engine + blower = 350rwhp

problem solved

[stieny]

Or this:

http://youtu.be/ei4FkUArEZg

This was my old GT. Bolt-ons, catted x and cat back, Zex 125 wet shot with supporting mods, and a custom tune.

It put down 361/506 with stock long block and manifolds.

[SK@StreetLethal]

No problem at all boosting an engine with some miles on it. However I would recommend doing a compression and leakdown test to make sure it had a clean bill of health. If it has any weaknesses you will find out quickly with boost.

[98gt]

I currently have bbk full length headers and off road x pipe with flow master cat back. most likely getting a blower and low boost. any suggestions on what type?

[SK@StreetLethal]

Depends what type of driving or racing your planning to do?

[no1sirbutler]

Depends what type of driving or racing your planning to do?

Listen to this guy!!!!!! He knows his stuff.

[somethingclever]

s trim