bore limit for 351 W

[Mark Aubele]

Best two statements in thread. Threads like this is why scs is dying and the young bloodz have taken over? Whats next thread? How much hp can a stock block handle or i know how do i get traction?

Probably a thread about roll racing

[torqueboxer]

To OP don't get upset but your question was kinda off base. These sites ARE for questions to be answered with, but, your questions were not really thought out for the aspect of getting legitimate answers. I.E " hey guys I have a Windsor I would like to upgrade to put in my car, previously it made xxxx hp I would like to know if anyone had any suggestions". There are a few experienced Windsor builders on this site ( myself) and good info can be had here, if the right LEGIT questions are asked. There have been multiple posts on different 351combos on this site. But when you start on with completely unrealistic goal your gonna get flack for it. We are here to help but get annoyed with rediculous stuff

[phillysrt4]

Dont be dissin the roll racin, yo!

oh wait- i drove an srt4- erm... nevermind

[k7cobra]

To OP don't get upset but your question was kinda off base. These sites ARE for questions to be answered with, but, your questions were not really thought out for the aspect of getting legitimate answers. I.E " hey guys I have a Windsor I would like to upgrade to put in my car, previously it made xxxx hp I would like to know if anyone had any suggestions". There are a few experienced Windsor builders on this site ( myself) and good info can be had here, if the right LEGIT questions are asked. There have been multiple posts on different 351combos on this site. But when you start on with completely unrealistic goal your gonna get flack for it. We are here to help but get annoyed with rediculous stuff

point taken i do understand the way i put my words. so let me correct my self. the motor windsor motor i have is making 450 and was reciving a 150 shot the motor was installed in a 71 torino 500. i really dont want to use spray so if i can not reach this goal with a small block im going to buy one of my father in laws 514 big blocks. to get the job done so with that being said what do you think should i spend the money to build the small block or buy a motor that i seen run 9s. so all suggestions are welcome and sorry for not typing this right the first time

[Dan B.]

what do you think should i spend the money to build the small block or buy a motor that i seen run 9s. so all suggestions are welcome

Read Ben's (torqueboxer) signature......that's a good tip on how to get a small block into the 9's.

[Mark Aubele]

Read Ben's (torqueboxer) signature......that's a good tip on how to get a small block into the 9's.

Or the 10s. Once.

[torqueboxer]

All depends on$$$$. I dont know what hes charging you for a 514 but figure on about 4000$ on top of the price of the motor....dont beliveve me? Headers 600+, new oil pan for foxbody 7qt minimum 350+, motormounts 150, radiator250+, new hood plus paint 600+, transmission/ converter/ shifter/ driveshaft 1600+ , kmember/ manual rack/ springs to hold up the bigblock 600+, 3 1/2 inch exhaust to hookup to new motor250+, fuel system to feed 700hp sumped tank pump lines fittings 500+ (1000$ to do it right) plus a 6al ect. Thas buying the MINIMUM priced parts. Just an idea

[TooFast98Cobra]

BBF equals boat anchor. Give me 6 gs and buy your self a decent power adder and ill give you 1200 plus hp out of a sbf

[went9s]

Or the 10s. Once.

LOL