What did you do to your stang today?

[95V6]

Haha - breaded lines - someone had too much to eat today!!

Haha! Didn't even catch that.

[Darren]

Ive had so much food today I cant even walk lol

[blzim21]

New Front control arms and alignment

[cLockWise]

Finally drove mine today. Put a Duracel battery in it.. Also put some tinted tails in today. Looks good.

[speedracer]

Probably going to be another 2 weeks... :(

[Dan B.]

Took a roll around in the T-bird today. It's tough trying to drive a stick with the leg/foot cast so I had the wife drive. Going to wash it up Friday and will snap a few pics.

[cLockWise]

Probably going to be another 2 weeks... :(

That really sucks

[Dan B.]

That really sucks

He's short. Someone probably borrowed his step stool and he can't reach the door handle. So he had to order a new stool.

Hopefully they didn't take his booster seat also.

[cLockWise]

He's short. Someone probably borrowed his step stool and he can't reach the door handle. So he had to order a new stool.

Hopefully they didn't take his booster seat also.

Haha man.. You weren't holding back on that one were you Dan? Lol

[95V6]

Finally drove mine today. Put a Duracel battery in it.. Also put some tinted tails in today. Looks good.

You gotta get that dealership decal off the trunk.

[cLockWise]

You gotta get that dealership decal off the trunk.

It honestly doesn't bother me lol. But I'll get to it at some point.. I need to order my sequential tail light kit, and then I need to goto a junk yard and grab one of the relays so I can mod it to slow down the timing, rather than paying 40.00 for a f'n raxiom turn signal adjuster.. I highly doubt its any different than what I'm going to do.. Cause I don't know how they would be able to keep the front turn signal at normal time, and the rear turn signal slower.. doesn't make sense to me with that relay switch as far as adjusting two portions of the car lol.. If you follow me? Or am i talking jibberish :(

[95V6]

If you know how to do it, go for it. I'd rather spend the 40 and skip the b.s.

[95V6]

Car looks good by the way. Could use some tint and a drop.

[cLockWise]

If you know how to do it, go for it. I'd rather spend the 40 and skip the b.s.

Its extremely easy.. All you have to do is pull the relay unit, open it up, then pull out the capacitor and replace it with one that slows down the timing.. I think the stock one is like 3.3 or something. And the new one is 4.7.. Its like 2.00 at Radioshack lol.. Then you solder it in and its done..

Car looks good by the way. Could use some tint and a drop.

Thanks man.. Tint will be done this year, that was something I wanted to address last year and I didn't get around to it. I modded the car early last spring (April) by putting on my Magnaflow setup, but never touched it again because I was so busy with work. I didn't even go on a lot of cruises, or do much with it.. So I'm hoping this year to get the tint on it, long tubes, new clutch, firewall adjuster, quadrant, and gears.. I still have the bullitt's that need to be put on yet. I won't put them on until the roads look better..
Next year I plan on dropping it, not sure what I want to go with? Any suggestions on what i should buy? I haven't looked into that yet

[95V6]

I like my H&R SS springs. Nice stance, I want to drop it more but that's just me. Picture in sig is H&R SS with no iso's.

Here are a few pictures from last summer with that set up.

ImageUploadedByTapatalk1365133456.122584.jpg
ImageUploadedByTapatalk1365133493.544639.jpg
ImageUploadedByTapatalk1365133516.123423.jpg

As you can see I can still drop a little more.

[cLockWise]

Looks good man. What are ISO's (sorry I don't know a lot about suspension mods and all that stuff). I need brought up to speed on some stuff. I'm still learning.. Suspension has never been my thing.
What kind of price tag does the H&R setup run? Your car looks great, I like the stance of it, just trying to get some ideas on what to do for when I actually pull the trigger and do it myself!

[95V6]

Iso's are isolators. They are rubber boots on the top and bottom of your springs. They prevent metal on metal rubbing and noises. A lot of people don't run them for a tad more drop. Maybe half an inch and that's being generous. I've have no problems, squeaks or noises from mine.

It runs around $260, sometimes you can find them on sale for $240.

[cLockWise]

Iso's are isolators. They are rubber boots on the top and bottom of your springs. They prevent metal on metal rubbing and noises. A lot of people don't run them for a tad more drop. Maybe half an inch and that's being generous. I've have no problems, squeaks or noises from mine.

It runs around $260, sometimes you can find them on sale for $240.

Ahh okay thanks for the literature, had no idea what the hell an Iso was.. I've saw people mention it a few times, but was like wtf is that lol.
How much did the H&R's drop your car?? Mine obviously is up a bit higher than the 01+ gt's I believe.. By 3/4" I believe?

[95V6]

inch and a half? Not quite sure.

[street591]

H&R SS or Eibach Pro-Kit in my book. Both go great and give a perfect drop with no isos. Any lower, and I highly recommend MM coilovers.