Hi guys.
A while ago someone posted a good thread about how to glue some Cobra emblems onto auto parts store floor mats to make them look like expensive embroidered ones.
I cannot find the thread.
Anyone remember this one?
If you can point me to it, I would much appreciate it.
Thanks.
03 Cobra redfire vert - 466 rwhp / 456 rwtq
Mods: Bassani Mid Length Headers, X Pipe and Cat Back, Accufab Big Oval Throttle Body And Polished Inlet Plenium, 2.95 Reichard Ultra Grip Pulley, MotoBlue Auxiliary Idler Pulley Kit, LFP Double Pass Heat Exchanger, K&N FIPK, C&L intake Pipe, 3.73 Gears, MGW Shifter, Spec stage 2 clutch, Fidanza aluminum flywheel, MotoBlue Hard Launch Bar, Full Tilt Boogie Racing kit and H&R Race springs
Many thanks!Originally Posted by Monkeygrits
I thought that I had subscribed to it but must have not.
Appreciated.
Now the challenge is finding the embroidered emblems.
All I see are metal ones on eBay anymore.
03 Cobra redfire vert - 466 rwhp / 456 rwtq
Mods: Bassani Mid Length Headers, X Pipe and Cat Back, Accufab Big Oval Throttle Body And Polished Inlet Plenium, 2.95 Reichard Ultra Grip Pulley, MotoBlue Auxiliary Idler Pulley Kit, LFP Double Pass Heat Exchanger, K&N FIPK, C&L intake Pipe, 3.73 Gears, MGW Shifter, Spec stage 2 clutch, Fidanza aluminum flywheel, MotoBlue Hard Launch Bar, Full Tilt Boogie Racing kit and H&R Race springs
Oh. I found them under "patch" and not "emblem".
I am good to go now.
Cannot wait to make a set.
03 Cobra redfire vert - 466 rwhp / 456 rwtq
Mods: Bassani Mid Length Headers, X Pipe and Cat Back, Accufab Big Oval Throttle Body And Polished Inlet Plenium, 2.95 Reichard Ultra Grip Pulley, MotoBlue Auxiliary Idler Pulley Kit, LFP Double Pass Heat Exchanger, K&N FIPK, C&L intake Pipe, 3.73 Gears, MGW Shifter, Spec stage 2 clutch, Fidanza aluminum flywheel, MotoBlue Hard Launch Bar, Full Tilt Boogie Racing kit and H&R Race springs
Posting Permissions
Reply With Quote
Bookmarks