Project White POS

[cwh19]

Cliff Notes:

- Previously stock 302 with HCI, vortech
- 428/414 on a mustang dyno
- No track times
- Motor went boom.


New Drivetrain:
- 410w
- s478 borg warner
- faceplated t56
- stock rear with 4.10s (for now)


Other New Misc:
- 6 point with swing outs
- Smoothed engine bay
- Wire tuck
- Megasquirt
- Other random interior crap

Pictures:

[cwh19]

[cwh19]

[cwh19]

[cwh19]

I have more just not on this computer. Ill put them up later.

[95V6]

Super clean build! Very nice work!

[cLockWise]

Nice job colton, looks good man!

[2000GT]

Looks good. I can't wait to see the finished project.

[John4cam]

Thats some serious piping for that hair dryer. Any power or ET goals?

[pwtmxracing]

Looking good nice build

[cwh19]

Thats some serious piping for that hair dryer. Any power or ET goals?

The downpipe flange off the turbo is 5" so I wanted to keep the pipe the same diameter for as long as possible. I don't have it going that way anymore but for some reason I can't find any of my other pictures.

I want to hit 750whp on a Mustang dyno and go at least 135 in the quarter. With stock rear end and trying to drive it this year as such, I am gonna leave soft so the time probably wont be good.

[SlowSix]

Start up vid of said white pos.

[ame="http://www.youtube.com/watch?v=FXclYVlVXAU"]White pos lives! - YouTube[/ame]

[cLockWise]

Nice!

[John4cam]

wow, you need a respirator to sit in the drivers seat! Haha, Sounds good.

[Martin0660]

Start up vid of said white pos.

Nice garage troll you have there

Have you done any further tuning on it?

[cwh19]

Nice garage troll you have there

Have you done any further tuning on it?

Hahahah ill let Mr Pardus know.

I have some yes. I drove it around the block twice last year but that was it. I was having some fan issues and it was getting hot. Since it was heading back into crappy weather I took everything back apart and powder coated stuff. Its relatively close now. I bought the tunderstudio subscription last year but haven't actually used it yet.

[cwh19]

wow, you need a respirator to sit in the drivers seat! Haha, Sounds good.

I figured id go the diesel route haha. That was first startup which actually took place in May of last year. It was like 9.9 idle air/fuel. This project started in September 2011. I hope to have it on the road by the middle of May.

[95riosnake]

Put a flapper on that downpipe and keep it like that lol, imagine the attention that would get from the fuzz!

[cwh19]

[KeystoneJohnny]

Nice build! Looks like a lot of work but is looking sweet.