So putting my car together. The car was a basket case still missing a ton of parts but i am concerned at the problem at hand. I have the engine and trans installed and everything tightened down put the shift boots and handle on and then started shifting thru the gears and when i shift it in 2nd and 4th the shifter hits the bezel for the boot. I know for 100% that the handle isnt backwards and it is going all the way in the gear after it pushes the bezel out of the way a lil bit. The only thing I can think of is that I am not using the exhaust hanger on the transmount and that not using it is lowering the trans enough to make the shifter hit. You guys think I am on the right track or should I keep looking.