I am selling a 1996 Mustang Gt, with a 5 speed. There is currently 107K. Has been garage kept and driven only in the summer. I have done a lot of work to it and needs to be seen to be appreciated. I have owned it since 1998. It has a clean title and no accidents
The short block is from a 2003 Mach 1, the heads are from a 2003 mustang gt and cams are comp cam 268. The cams are timed within a half of degree or each other, has a high flow oil pump and extra cooling loop at the rear of the heads. The compression is 13:1 and runs great on 93. It has BBK full length ceramic headers, custom catted h pipe and Flowmaster exhaust tucked up as high as possible against the bottom of the car without rattling.
Some of the other highlights are:
Aluminum flywheel
HD clutch
Aluminum drive shaft
3.73 gear
F-150 limited slip
31 spline axles
Maximum Motorsports suspension parts:
offset front control arms
bilstein struts with 350lb springs (425lb springs in a box)
caster camber plates
upgraded steering rack
hd tie rods
aluminum rack bushings
hd steering rack shaft
full length subframe connectors
Adjustable height rear lower control arms
bilstein shocks, grooved for coil overs
175 lb rear springs
Panhard bar
Basically missing two parts for a full on road race suspension: a tubular k member and torque arm.
Wheels are Saleen replicas 18 x 9 with pretty worn 265/35/18 bfg kdw2. I have (2) new 285/35/18 nitto 555 that would be a good rear tire. Brakes are 13" in the front and 12" in the rear from a 01 bullitt mustang
Was referred to this website by a guy who bought the stock wheels off me earlier this week. Looking to get $5500 and am located in plum.
Reply With Quote
Bookmarks