I am putting toghether a top end and a N20 kit on a friends car. Any n2O tuning tips?
Also change plugs out for 2 heat ranges colder.
it be no different then anyother stang today then. newer stangs all have craper pistons..i mean hypers
with a 93 block i would probably go 4*
I would get evey thing working and spray it on the dyno for the first time. Just to make sure your air fuel is ok and that you don't have any other problems that could damage your engine. You may want to consider a tune for your car so you can have an N/A tune and a nitrous tune so you don't have to change your timing all the time.
Chris Kauffman
2000 Vortech'ed Saleen replica
1991 302 LX notch Saleen replica
1988 408LX drag car
1988 460LX drag car (new project)
You basically go with a switch chip setup so you can switch from mulitunes. You have the car tuned for N/A and than for the nitrous. Then you can switch back and forth from your two tunes as you need them.
Chris Kauffman
2000 Vortech'ed Saleen replica
1991 302 LX notch Saleen replica
1988 408LX drag car
1988 460LX drag car (new project)
anderson ford motorsport PMS
Roll With The Mill Creek Mafia
709RWHP/750RWTQ
I happen to have an extra one if your looking to buy one.
Roll With The Mill Creek Mafia
709RWHP/750RWTQ
Yea id say definitly put it on the dyno and make sure your air/fuels alright. I got the SCT chip with a with a flip switch and i love it. Up to 6 differnt tunes at your finger tip
06 Custom Hardtail Honda SS750
00 Yamaha V Star 1100
88 Ford F250
Bookmarks