So when redoing the internals of a manual mach1's engine must upgrade the crank or can you just do pistons and rods?
So when redoing the internals of a manual mach1's engine must upgrade the crank or can you just do pistons and rods?
Rods and pistons will do. Your crank is fine as long as it is a 5 speed.
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
DO the machs have forged cranks or not?
5 speeds are forged, auto's are notOriginally Posted by Rodeheaver's
Who's the genius at Ford that came up with that one?
Truely stupid idea.
Must have been cheaper than designing a new 8 bolt flex plate
2015 Charger Hellcat
2.4" upper pulley, ID1300 injectors, BAP, E85 tune, Cat Delete Pipes, One Piece Drive Shaft, Diff Brace, 305/35/20 555R's for the street and 305/45/18 MT ET Street R's for the track. 9.97@142 Best ET
85 GT
Heads and Cam plus other bolt ons
73 F250
Lifted, 35's, 460 4spd
Real name = Ray
Didn't some 96-02 cobras have auto's? If so they could have used that flex plate. Also 99-00 GT's have 8 bolt flywheels they could have used those too. Who really knows why ford did that?
665/540 New times coming
Old times with 516/453 11.10 @129 Best trap 130.69 -750' DA lol
DYNO VID ---> http://www.youtube.com/watch?v=K9uOS732mdA
Posting Permissions
Reply With Quote
Bookmarks