Thanks guys!
Ed- unfortunately, his car is just that much lower than mine. I actually lowered my car this year too! That was one of the biggest reasons that I ditched the xenon pieces as they hung down like 2" below the frame of the car on the sides. I can not go any lower as the approach angle into my garage is at a pretty severe angle. At the height it is now, I do not have enough room between the pinch weld of the car and the peak of the angle where my driveway meets my garage to stick my finger in between! I'm waiting until the rear bullitt springs are done settling before I touch the front coil-overs. Once I know the rear is done, I will lower the front as much as I can so I can just make it into the garage.
Plus, I'm afraid to go any lower for fear of hitting my canton pan on the ground, it is the lowest point on the car now.
Reply With Quote
Bookmarks