rearend is ready

[eddmann55]

i got a rear with rear discs, and 3.73's off donstang from an 88 s/c, I cleaned it up new calipers,rotors, brake lines, now it's ready to put in my 88 vert

[Martin0660]

You know the TC rear is 3/4" a side wider right? Also, the quad shock brackets are at a different location (but can be redrilled). Also, did you copy the TC brake line routing, or copy you fox?

Bob Myers

[eddmann55]

i know about it being wider and i need to drill holes 2" lower for the quads, but i copied the s/c lines, should i have copied the fox?

[Martin0660]

Take a look under your car, but on mine, the brake lines (84 fox) come down to where the breather tube is on the right axle tube. On the TC, they come down on the other side, so your rubber line and block might not work.

[eddmann55]

ok, thanks a lot, don said if i had problems you were the guy to talk to about this, i appreciate your help, i never even thought about that, now i know to look for that. while on the subject what master cylinder do you recomend, one from t/c or cobra, or will any ford near that year with rear discs work

[Martin0660]

Well, the disc brake TC master cylinder is a electro-mechanical (TEV's) system, so no help. I know folks that have used the SVO master cyclinder, as well as the 93 cobra master cyclinder too. My buddy Frank has the SVO master cylinder on his right now with the TC rear and says the brakes are okay, but he has small fronts. I actually think the cobra and SVO might be the same, but never looked into it. My car is all SVO brakes, so of course I use that master cylinder and it works great.

I think any of the disk brake master cylinders will work, the bigger problem might be with the proportioning valve. This might help you.....

http://mjbobbitt.home.comcast.net/mustang/4lug.html

Bob Myers


Bob Myers