Well here is the problem.. Three of the holes in my axles are stripped out. When i switched my tires they were really loose and i thought maybe it was just the stud so i got three new studs put them in and still the same thing. These wiggle so bad that it loosens my lug nuts to the point every time before i drive i have to tighten them up. So what should i do? Should i tack weld the three loose ones? Put some good ole JB weld? or what should i do?
pound them out, install new ones
I did that.. the inside of the hole on the axle is stripped smoothOriginally Posted by Quik
I don't think it is supposed to be threaded in the 1st place. The studs should press in.
That's from doing all them burnouts
"No man is entitled to the blessings of freedom unless he be vigilant in it's preservation"
General Douglas McArthur
I wouldn't put my life on the line, get a new or used replacement axle. All gt v6 and cobras from 94 - 98 are the same.
Lou
Best non ported stock pullied eaton pass
1.50 60ft 11.160@ 125.08
New combo,
Ported Eaton, upper/lower
508 Hp 548 TQ SAE on an inferior Dynojet Dyno
1.43 60 ft. 10.55 @ 130 MPH
WFC 8 Mod Motor Winner
06 NMRA Martin, Mi. Mod Muscle Winner
it feels like and looks like there are notches in the axle
Did you use the wrong diameter stud?
get new one that has a larger NULL but if doing this make sure you do all your studs like this
Posting Permissions
Reply With Quote
Bookmarks