mustang stuff

**biggb** · 10-31-2007, 06:24 AM

edelbrock performer rpm2-450.00
3/8 intake spacer included also

edelbrock performer rpm heads-2.02/1.60--750.00
with hardened pushrods

crane 1.6.1 stud mount rocker's 3/8--100.00

306 shortblock---1000.00 ready to go
balanced
oringed block
race prepped rods from dss
forged scat crank
forged trw 8.5.1 pistons
arp studs through out the bottom end
fresh rings bearings
comp custom turbo cam
edelbrock timing chain
ford racing sfi balancer
tci 157t flexplate
summit BRAND NEW 75mm tb w/egr spacer--100.00

mac 1 5/8 longtube headers --100.00

superior 28 spline drag axles--100.00

bbk 1 5/8 long tube headers--125.00

bbk 2.5 o/r x pipe (for long tubes)--75.00

flowmaster catback(dumps)---75.00

crane hi6r w/ map sensor and trc controller--175.00

crane ps coil(tfi) ---25.00

3 gauge pillar pod---20.00

email ruthlessgsx@aol.com or call 814-207-3299
prices are firm i will take trades on anything mustang specific..

**HOTMARK7** · 10-31-2007, 02:41 PM

are the mac headers for an auto or stick

**scott5** · 10-31-2007, 02:42 PM

What did you mount the x-pipe up to the MACs or the BBKs?

**Viper_ed** · 10-31-2007, 02:45 PM

Is this the same stuff you had on turbomustangs.com? I thought the heads were sold?

Are the axles 4 or 5 lug and are they C-clip?

**biggb** · 10-31-2007, 10:03 PM

the x pipe is gone
the mac headers are for a manual only
the axles are 4 lug and yes they are c clip
yes it is the same stuff, i thought i had stuff sold and then i was going to keep it all, but changed my build and its final so all must go...