Need an exhaust manifold

**PaxtonShelby** · 11-21-2007, 02:35 PM

Hi folks,

I'm looking for a driver's side exhaust manifold for my '66 GT coupe.
I recently pulled the motor and discovered that the manifold had cracked off by the first bolt hole. I don't have the part # handy, but I'll check when I get home from work, as it is cast right into the manifold. I'd like to have the correct part #, not just something that will fit, as the car is really original and I want to keep it "basically" stock.

It doesn't have to be like new - just in good solid condition - as I plan to bead blast them and have the manifolds ceramic coated with a cast iron finish.

Thanks for looking.

A few years ago I threw a few of these away...dang it!!!!

**Sonic03snake** · 11-21-2007, 03:44 PM

Get me that number and ill see what I have.

**Stangman701** · 11-21-2007, 04:22 PM

My dad might have a set. If you get the number posted up here before the weekend I'll try to look when I go home this weekend.

**PaxtonShelby** · 11-21-2007, 06:17 PM

Thanks guys - I appreciate the quick help! I'll try to post the part # up tonight. Have a nice calorie-filled holiday!!

**PaxtonShelby** · 11-21-2007, 07:52 PM

Here's the part #. Again, this is for the driver's side exhaust manifold....

C6OE-9431-C

It is cast right into the middle of the manifold between the 2nd and 3rd ports.

There's also a casting # that is perpindicular to the one above - not sure what this is for, but here it is...

5025

I don't think it matters for the driver's side manifold, but this is a San Jose car that has the complete California emissions setup on it. The passenger side manifold has some extra stuff cast into it, with various lines running to and from. I guess I'm glad the passenger side didn't break - I bet it would be a lot tougher to replace...

I'll try to post a pic later if I can, but I have to run now.

Thanks guys.

Ron