Ok, when driving my mustang after we just replaced the clutch, flywheel, pilot bearing, and throwout bearing, when at high rpms, in N, it will make like a metal spinning on metal noise, kind of a whine, is this a bad throwout bearing or what?
because if its the throwout bearing im gonna be pissed after i spend $600+ for this clutch kit, then the bearing is bad, and i have to rip it all out again...
Thanks for the help SCS!!
Fox/n.
1. wild animal : a carnivorous animal of the dog family that has a sturdy square body, large cubic inches, a wide RPM range , and comes in many colors. Foxes are found throughout most of the world and hunt alone, mainly at night, relying on cunning and an acute sense of power and acceleration. They feed on mostly small rodents like rats(BBC) , mice (SBC) and snakes(Cobras).
does it go away when you press the clutch in?
2013 Mustang GT
1987 Mustang GT
1999 Contour SVT
No thats the only time it does it, when the clutch is pressed in, in N, and i rev it..
Fox/n.
1. wild animal : a carnivorous animal of the dog family that has a sturdy square body, large cubic inches, a wide RPM range , and comes in many colors. Foxes are found throughout most of the world and hunt alone, mainly at night, relying on cunning and an acute sense of power and acceleration. They feed on mostly small rodents like rats(BBC) , mice (SBC) and snakes(Cobras).
hmm...im not sure then. I had a whining noise before that went away when the clutch was pressed in. it turned out to be the pilot bearing. maybe someone else can chime in for help...i would check to be certain that its comming from the tranny area and not under the hood
2013 Mustang GT
1987 Mustang GT
1999 Contour SVT
fluid in the tranny??
ridin fast,hittin da hills,throwin some dirt
2003 polaris predator 500
(wanna ride,just pm me!!!)
Posting Permissions
Reply With Quote
Bookmarks