Anyone know what is recommended to do to this motor to get it where it would be safe to put a S/C on it?? I have it on a motor stand in the garage and its going to be my winter project, I know there are differences between it and the Cobra DOHC, but I am not sure what all is different between the two, besides the intake
www.markviii.org, lots of good info there!
If you're going to run less than 10 pounds of boost you're probably good as is. But what fun is that. Throw in a crank from an 03-04 cobra or a 5 spd. Mach 1, some decent rods again 03-04 cobra rods should work fine, and a set of forged pistons that would put the compression around 8.5:1 and you should be good up to 20 lbs. of boost or more
2015 Charger Hellcat
2.4" upper pulley, ID1300 injectors, BAP, E85 tune, Cat Delete Pipes, One Piece Drive Shaft, Diff Brace, 305/35/20 555R's for the street and 305/45/18 MT ET Street R's for the track. 9.97@142 Best ET
85 GT
Heads and Cam plus other bolt ons
73 F250
Lifted, 35's, 460 4spd
Real name = Ray
Posting Permissions
Reply With Quote
Bookmarks