bell housings on 4cyl and 6 cyl manual cars

[phillysrt4]

they're the same right? they look that way from what ive seen.

[Rodeheaver's]

if you set the both down on the floor (engine side down), you will see that the v6 is deeper for some reason, and the imput shaft on a v6 tranny is longer ..

[Martin0660]

The 2.3L 4 cylinder stuff is unique on the block side. I wish something even V6 would work, that would open some more options.

Bob Myers

[phillysrt4]

if you set the both down on the floor (engine side down), you will see that the v6 is deeper for some reason, and the imput shaft on a v6 tranny is longer ..

The 2.3L 4 cylinder stuff is unique on the block side. I wish something even V6 would work, that would open some more options.

Bob Myers

Crap... so that means a bell and input shaft change if I go with a tranny from something other than a 6 :(

[J-rod]

Crap... so that means a bell and input shaft change if I go with a tranny from something other than a 6 :(

[phillysrt4]

that sucks... there is a t5 in the for sale section that would have been nice had it not been for this :(