Quadracer LT250R

**wick** · 03-14-2008, 10:43 PM

Well, I am selling my quad. The one that I just completely rebuilt. Its pretty much brand spanking new. Sandblasted the frame and all other steel parts. Re-built the motor and transmission. Every bearing has been replaced and the motor has a new seal and gasket kit. Cylinder is 1.50mm over and brand new. Reeds appeared to be brand new, I did not replace them. Has a Durablue axle +1 +2. Douglas polished rear 10" rims. 2006 LTZ400 shocks. Converted to thumb throttle. Answer bars. FMF elite series exhaust. Decent tires. Looking for a fast sale at a reasonable price of $1500. Remember, this thing is basically a brand new '91 LT250R!!! The only thing that sucks is the plastic. It was yellow and not the best so I painted it black with Fusion plastic paint. Not too bad.

$1500 OBO

**wick** · 03-14-2008, 10:49 PM

This thread will take you through most of the re-build.

http://www.steelcitystangs.com/forum...ead.php?t=7142

**somethingclever** · 03-15-2008, 01:44 PM

Thats a screamin deal!!! Good luck with the sale Rob.

**wick** · 03-15-2008, 01:46 PM

Thanks John. Get that welder yet?

**dpstang98gt** · 03-15-2008, 04:03 PM

man i really wish i didnt just buy my 02 blaster or i would be all over this...real nice looking bike man

**tylerstepp** · 03-15-2008, 08:01 PM

pm sent

**wick** · 03-15-2008, 10:06 PM

Originally Posted by tylerstepp

pm sent

Returned and called. Thanks alot Tyler!!!!

**somethingclever** · 03-16-2008, 05:34 AM

Originally Posted by wick

Thanks John. Get that welder yet?

I've been putting it off so far...the nice weather is around the corner so that will be some motivation. :)

Pretty sure i'm going with a 110v Lincoln...should be good up to 3/16th.

Hi-jack over....

**chevydad** · 03-16-2008, 11:54 AM

very good price.

**wick** · 03-17-2008, 09:19 PM

SOLD!!!!!!!!!!!!! This was the easiest transaction I have ever had on steelcity. Thanks alot!!!

**wick** · 03-17-2008, 09:21 PM

Originally Posted by somethingclever

I've been putting it off so far...the nice weather is around the corner so that will be some motivation. :)

Pretty sure i'm going with a 110v Lincoln...should be good up to 3/16th.

Hi-jack over....

Good choice. If you get the top one, I think its a 140 amp, you should be able to go to 5/16. Its a short duty cycle on the thicker steel but its a nice welder. If you have any questions, give me a ring.