WTB: T-45 T45 Tranny or t-5 with 4.6 bellhousing?

[onenastytbird]

Its been quite some time since I last posted this but nows getting the time the cars ready for its new drivetrain, so what does everyone have to offer? I been shopping these forever it feels as im not paying top dollar for one. So please just let me know what the lowest is your willing to take for it. Thanks for any replies

[onenastytbird]

noone has one they wanna sell or trade???? Looking to get one asap as I have my motor now and am ready to get this car rollin ;)

[393rag]

I have a t5 that needs 2nd gear synchros that I'll sell you for $200.

[onenastytbird]

this will fit a 4.6? 200 seams a bit steap for one needing rebuilt.

[393rag]

I'm not quite sure what you have to do to make a t5 bolt to a 4.6. It's out of an SN95, so the length should be ok. I would assume any t5 you get may need to have the input shaft replaced to mate up with the 4.6, and obviously change the bellhousing. If you want it, make me an offer.

[ocracing]

you need a aftermarket bell to put the t5 behind a 4.6.the trans you need the bell is part of the transmission.i might have one i will look.

[393rag]

you need a aftermarket bell to put the t5 behind a 4.6.the trans you need the bell is part of the transmission.i might have one i will look.

There is a website that sells an aftermarket bell to mate a t5, tko to a 4.6, but I can't remember the name off hand. They specialize in bells to fit just about any tranny to any motor.

[Viper_ed]

There is a website that sells an aftermarket bell to mate a t5, tko to a 4.6, but I can't remember the name off hand. They specialize in bells to fit just about any tranny to any motor.

Might be JW Bell.